Kenmore 580.72184 Am Drainage Drain holeis providedat the rear of theair, Screw FIG, Part

_Pull the bottom window sash down behind the upper guide until they meet.

NOTE:

•Do not pull the window sash down so tightly that the movement of sliders is restricted. Attach the cabinet to the window inner sill by driving the screws (ITEM F) through the cabinet into window inner sill.

•The cabinet should be installed with a very slight tilt downward toward the outside 1/4" from level.

Windowsash

°Connect a drain elbow of 9/16" inside diameter to

the drain pipe.

•Connect a drain hose of 9/16" inside diameter to the drain elbow, (Drain hose is not supplied.)

	I	I Drain
_]	Dlrbainw"DTrain
FIG. 13		hose

FIG. 10

_ Expand side curtains to fill opening.

Attach each side curtain to the window sash using 4 screws (ITEM G). (FIG. 11)

ITEM G

LowerGuide

FIG. 11

_ Slide the air conditioner into the cabinet. (FIG. 14) CAUTION: For security purposes, reinstall side screws that were removed in step 1,

Cord

Screw

Screw FIG. 14

_]Cut the foam seal (ITEM K) to the proper length and insert between the upper window sash and the lower window sash. (FIG. 15)

_] Attach the window locking bracket (ITEM L) with a screw (ITEM G). See FIG, 12.

FIG. 12

am DRAINAGE

Adrain holeis providedat the rear of theair

conditionerunit.Select a drain method accordingto the following.

-Remove the holerubberfrom the base-pan.

FIG. 15

_] Adjust the vent handle before the decorative front is attached, (FIG, 16)

Straighten the lever, as shown. Pull down part ®to align with part ®.

Part (_)

Part(_ FIG. 16

-7-