DAVIS 6322C installation manual Contents

Page 2
Contents

Contents

 

Introduction

1

Included Components and Hardware

1

Cabled ISS Assembly

7

Wireless ISS Assembly

9

Preparing the ISS for Installation

13

Installing the ISS

19

Installation Instructions

20

Maintenance and Troubleshooting

25

Appendices

28

FCC Part 15 Class B Registration Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a res- idential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modification not expressly approved in writing by Davis Instruments may void the warranty and void the user's authority to operate this equipment.

FCC ID: IR2DWW6328

IC: 378810-6328

EC EMC Compliance

This product complies with the essential protection requirements of the EC EMC Directive 89/336/EC.

Integrated Sensor Suite Installation Manual

Rev. E, April 7, 2008

Document Part Number: 07395.249

For Vantage Pro2 Weather Stations # 6322, 6322C, 6323, 6327, 6327C, 6328 For Vantage Pro2 systems 6152C, 6162C, 6152, 6162, 6153, and 6163

Vantage Pro® and Vantage Pro2are trademarks of Davis Instruments Corp., Hayward, CA.

© Davis Instruments Corp. 2006. All rights reserved. Information in this document subject to change without notice.

3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.

510-732-9229 • Fax: 510-732-9188

E-mail: info@davisnet.com • www.davisnet.com

Image 2
Contents Integrated Sensor Suite Installation Manual Contents Components IntroductionIncluded Components and Hardware Hardware Preparing the ISS for InstallationTools for Setup Assemble the Anemometer Check SIM Sensor Connections Check the Factory Installed Sensor Connections Open the SIM BoxConnect the Anemometer Cable to the SIM Verifying Communication with the Console Cabled ISS AssemblyApplying Power Troubleshooting Cabled ISS Communication Troubleshooting Cabled ISS CommunicationChecking Transmitter ID Wireless ISS AssemblyApplying Power to a Wireless ISS to eight different wireless stations. The defaultVerifying Data from the ISS Sensors Troubleshooting Wireless ISS ReceptionVerifying Data from the ISS Sensors Optional Changing ISS Transmitter ID Using Multiple Transmitting Stations Prepare the Rain Collector Preparing the ISS for InstallationClose the SIM Box Optional Insert the Metric Measurement Adapter Locating the ISS and Anemometer General ISS Siting GuidelinesAnemometer Siting Guidelines Locating the ISS and AnemometerOptional Wireless Transmission Considerations Optional Anemometer Cable Length ConsiderationsTesting Wireless Transmission at ISS Location ping tape around both the cables and the pole Installing the ISSGeneral ISS Installation Guidelines Orient the Wind VaneInstallation Instructions Installing the ISS on a Flat SurfaceGeneral Guidelines for Installing on a Pole Installing the ISS on a PoleAccessories for Pole Mounting Option 2 Installing ISS Only Guidelines for Installing the ISS on a PoleOption 1 Installing ISS and Anemometer Together Extending Wireless Transmission Range Finishing the InstallationAdditional Mounting Options Level the Solar and UV SensorsRelocating the Anemometer Optional Wireless StationsExtending the Console Cable Cabled ISS Only 4 Screw 3 Lock Washer Flat Washer Maintenance and TroubleshootingCleaning the Radiation Shield Rain Collector BaseMost Common Rain Collector Problem TroubleshootingCleaning the Rain Collector Cone Most Common Anemometer ProblemsContacting Davis Instruments To re-orientthe wind vane AppendicesAppendix A Re-orientingthe Wind Vane ISS Weather Variable Update Intervals Appendix B SpecificationsWireless ISS Cabled ISSINTERFACE SIM Board Display and ContentsSENSOR MODULE