Dakota Alert dakota alert wireless alarms and security equipment, ad-01 slave owner manual

Page 11

How to operate the Auto Dialer

How to Arm the Alarm System/Turn the Dialer ON:

1.Check that the voice message and at least one phone number has been programmed into the Auto Dialer.

2.Press 1 2 3 4 > ENTER. The Auto Dialer will show ‘ON’ on the display.

3.The alarms will become active after the delay time you have set has expired.

Quick guide: Press 1 2 3 4 > ENTER

How to disarm the Alarm System/Turn Dialer OFF:

To disarm the Alarm System or to stop the Dialer from dialing out after either the tamper switch (if connected and active) or an alarm input has been activated, key in the four digit user password code followed by ESC. The Auto Dialer will revert to the ‘OFF’ mode and must be re-set to the ‘ON’ mode as above.

Quick guide: Press 1 2 3 4 > ESC

AD-01 Slave Manual.indd 11

11

10/15/2009 10:20:45 AM

Page 10 Page 12
Image 11
Page 10 Page 12
Contents AD-01 Slave Auto Dialer AD-01 Slave Manual.indd 10/15/2009 102044 AM Contents FeaturesSet Up InstallationClosed input trigger. If the tamper output is not Tamper Alarm The tamper alarm is alarmedWhen the button on the back of the dialer Terminals can be connected to any existingHow to play back the message Advanced Operations How to program the Auto DialerHow to delete phone numbers How to program phone numbersHow to change the user password code factory default is How to designate telephone numbers to Alarm 1 and AlarmAD-01 Slave Manual.indd 10/15/2009 102045 AM Press N N = 0 without sound 1 with sound. Press Enter How to disarm the Alarm System/Turn Dialer OFF How to change the back-up battery How to reset the Auto Dialer Inside the battery compartment For step-by-step programming, refer to pages AD-01 Quick Reference ProgrammingTechnical Support Dakota Alert, Inc
Top Page Image Contents