Dakota Alert ad-01 slave owner manual Installation, Set Up

Page 4

Installation

Tools needed: Small Phillips Screwdriver; Large Phillips Screwdriver; Small Standard Screwdriver.

Set Up:

1.Install the back-up battery (included) into the auto dialer. Use a small Phillips screwdriver to remove screw above battery cover (Figure 1-2). Remove cover by sliding downwards. Plug in battery pack making sure not to force onto pins incorrectly. Put battery pack in space provided, close battery cover, and replace the screw.

Figure 1

1

4

5

3

2

3. Connect the power supply to the dialer by inserting

the red wire into the 12V+ terminal and the black wire into the OV terminal (Figure 2). Using a small standard screwdriver, turn the screws on the terminal to secure the wires.

4.The dialer can support two alarm trigger inputs (normally open) plus a tamper alarm output (normally closed).

4

AD-01 Slave Manual.indd 4

10/15/2009 10:20:44 AM

Page 3 Page 5
Image 4
Page 3 Page 5
Contents AD-01 Slave Auto Dialer AD-01 Slave Manual.indd 10/15/2009 102044 AM Features ContentsInstallation Set UpTamper Alarm The tamper alarm is alarmed When the button on the back of the dialerTerminals can be connected to any existing Closed input trigger. If the tamper output is notAdvanced Operations How to program the Auto Dialer How to play back the messageHow to program phone numbers How to delete phone numbersHow to designate telephone numbers to Alarm 1 and Alarm How to change the user password code factory default isAD-01 Slave Manual.indd 10/15/2009 102045 AM Press N N = 0 without sound 1 with sound. Press Enter How to disarm the Alarm System/Turn Dialer OFF How to change the back-up battery How to reset the Auto Dialer Inside the battery compartment AD-01 Quick Reference Programming For step-by-step programming, refer to pagesTechnical Support Dakota Alert, Inc
Top Page Image Contents