Dakota Alert CAD-05 Kit GSM, Auto Dialer owner manual Installation, Set Up

Installation

Tools: Small & Large Phillips Screwdrivers; Small Standard Screwdriver.

Set Up:

1.Set PIR and CAD-05 dipswitches to match. The first five dipswitches on both units (Figure 1-1 and Figure 2-1) need to be set exactly the same with the last 3 dipswitches on the PIR sensor (Figure 1-1) matching the 3 numbers on the sticker to the left of the dipswitches on the dialer (Figure 2-2). (Note: On the PIR sensor, “off” is in the down position. On the Dialer, “off” is in the up position.)

2.Install battery in PIR sensor (Figure 1-2) and mount at desired location. (Note: recommended to replace batteries every 6 months.)

Figure 1

1

2

3.Use a small Phillips screwdriver to loosen SIM card cover on dialer (Figure 2-3). Lift up on hinges. Slide black cardholder to the left and lift. Insert SIM card into the cardholder with the notch on the top (Figure 3). Close cardholder and slide to the right to lock into place. Close cover and tighten screw.

4.(Note: please read all of step 4 before continuing). Remove the battery insulator by pulling the tab on the keyfob. Plug the DC adaptor into the dialer (Figure 2-5) and plug into wall outlet. Wait 20 seconds. If your

4

Figure 2

2 1 7 3 6 5 4

CAD-05 Kit Manual.indd 4

10/15/2009 9:40:53 AM