99
LSQT1145
With a computer (VDR-D310/VDR-D230)
Check the contents, then click
[k] at the top right of window.
8Click [Finish].
Windows 2000 only:
The detection of device will start, after which it
will take several minutes for the computer to
detect the device. When detecting the device is
complete, a message that prompts you to reboot
will appear:
Click [Yes].
∫If any trouble has occurred while installing
DVD-RAM Driver:
When [Block] is selected in the [Driver Signing
Options] in the [System Properties], the
installation procedure will not complete. Select
[Warn] and try again.
To check and change the setting, select [start] #
([Settings] #) [Control Panel] # ([Performance
and Maintenance] #) [System] and select [Driver
Signing] of the [Hardware] tab.
∫About the [RAMASST] support tool:
[RAMASST] is a support tool for Windows XP
that disables the drive’s CD writing function so
that data can be written from a computer to a
DVD-RAM.
When you install the DVD-RAM Driver,
[RAMASST] is automatically installed and
displayed in [Startup].
1Insert the CD-ROM into the
computer.
The introduction movie starts.
Click [To continue the installation] at the end of
the introduction movie and then the [Setup
Menu] screen will appear.
≥If the introduction movie screen does not
appear, double-click the CD-ROM drive icon in
[My Computer].
2Click [DVD-MovieAlbum].
≥The software application may not run properly
if you cancel the installation at any point (e.g.
by pressing [Cancel]).
≥Depending on the operating environment, you
may be required to install DirectX 9.0c. If so,
click [Yes], and install it.
If you install the software in a computer that is
not compatible with DirectX 9.0c, the computer
may not work properly. If you are unsure
whether or not your computer is compatible,
contact the maker of your computer.
3Click [Next].
The computer must be rebooted for the driver
to work.
Installing
DVD-MovieAlbumSE
LSQT1145.book 99 ページ ２００６年１２月２８日 木曜日 午前９時３４分