replacing the power nozzle™ belt
For best performance, we recommend you replace your Rainbow Power Nozzle belt every 12 to 18 months, or when you notice decreased cleaning performance. Your Power Nozzle comes with one replacement belt, and can be easily changed in just a few minutes. This replacement belt is located in the spare belt pocket under the sole plate. For additional replacement belts, contact an Authorized Rainbow Distributor.
!WARNING: Always disconnect from electrical supply when servicing.
1.Turn the Power Nozzle upside down. Using a
2.Using both thumbs, push tabs on both sides of sole plate outward while lifting to unlock.
3.Next, insert index fingers into two side openings near wheels. Pull side tabs up while pushing in to lift off sole plate.
4.Rotate brush roll assembly forward (note that edge cleaning brushes are upside down) and remove.
5. a) Slide worn or broken belt off motor shaft with finger; b) Lift brush roll out and remove worn belt.
6.a) Place new belt over the end of brush roll assembly and slide on; b) Loop new belt around the pulley and position in the center of the brush roll.
7.a) Place brush roll upside down with edge cleaning brushes centered on top of two side tabs. Slide belt over end of motor shaft; b) Rotate brush roll assembly forward until edge cleaning brushes are face up. Spin brush roll toward you to position the belt on the center of the pulley.
8.Position sole plate over top of Power Nozzle cover. Press down until front, two side tabs and back tabs snap and lock in.
9.Using a
1 |
3 |
5a |
6 |
8 |
18 |
2 |
4 |
5b |
7 |
9 |