Therma-Stor Products Group UA-135H 3J Programming Notes, 3L Stop Start, Low Pressure Control

Page 14

FOR HVAC INSTALLER AND HOMEOWNER

5.3I Intermittent or Programmed Ventilation

With the damper in program mode (denoted by “Pr” when setting the damper operation) the system will operate the ventilation function according to the current ventilation program.

There are 4 programs available for ventilation Monday through Friday. There are also 4 programs for Saturday and 4 programs for Sunday. No other choice of days is available. Each program to be used has an “on event” called “START” which brings the ventilation function on, and an “off event” called “STOP” which turns the function off. Each START and STOP must be entered in to the controller.

To set or adjust the ventilation program:

1.Press the “PROG” button two times. The display will indicate “Program 1/start” at the bottom, and the hour display will flash.

2.Use the “SET” + or – button to adjust the hour for the Program 1 start time. Be sure to pay attention to the am/pm setting.

3.Press the “PROG” button again. The display will indicate “Program 1/start” at the bottom, and now the minute display will flash.

4.Use the “SET” + or – buttons to adjust to the desired minute setting.

5.Press the “PROG” button again to move on to the “Program 1/stop” event. The display will indicate “Program 1/stop” at the bottom, and the hour display will flash.

6.Use the “SET” + or – button to adjust the hour for the Program 1 stop time. Be sure to pay attention to the am/pm setting.

7.Press the “PROG” button again. The display will indicate “Program 1/stop” at the bottom, and now the minute display will flash.

8.Use the “SET” + or – buttons to adjust to the desired minute setting.

9.Pressing the “PROG” button again to move onto “program 2/stop” and begin the process again if setting the other programs. Follow the same procedure for each program.

10.To end the program process simply leave the control alone (don’t push any buttons) for about 10 seconds. The unit will remember any changes and return to “home state”.

5.3J Programming Notes

To run the ventilation program, the damper mode must be in the “program” mode (“Pr”).

The timer can be operated manually without changing the program by adjusting the damper mode from “program” to either “on” or “off”.

To delete a program after it has been entered, adjust the program so the “START” and “STOP” times are identical.

Occupants should determine ventilation times and rates. Therma- Stor makes no firm recommendations concerning when to ventilate. Common ventilation schedules include constant ventilation, ventilation based on occupancy times, intermittent operation, and seasonal ventilation.

Remember the control must be on for the unit to be functioning - make sure the green power indicator “ON” is lit.

5.3K Ventilating or Dehumidifying to Control Indoor Relative Humidity Levels

Fresh air ventilation may have a drying effect or a wetting effect on the indoor space, depending on the amount of moisture present in the outdoor air. Relative humidity is not a good indicator of outside humidity levels: use dew point measurements instead. Consider outside humidity levels when using the ventilation function of the dehumidifier.

5.3L Stop Start

During summer in hot, humid climates operating in ventilation mode will increase the moisture load in the home.

Consider reducing the amount or frequency of fresh air ventilation if indoor humidity continues to be high.

5.4 Low Pressure Control

If the low side refrigerant pressure drops to 15 PSIG, the low- pressure control opens and shuts off the compressor and impeller fan. It is an automatically reset control that will close when the pressure rises to 35 PSIG. Its primary function is to prevent damage to the compressor if a leak develops in the refrigeration system. It may also open if the unit is A) installed in a cool area (below 50 F) or B) installed where it is below 40 F and then started. Under these conditions, the unit will restart within several minutes. Until the unit warms up, it may repeat the cycle several times.

14

Ultra-Aire 135H Installer’s & Owner’s Manual

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Fresh Air Ventilation Hvac Installer Please Leave Manual for HomeownerUA-135H Part No Serial No Dehumidification Air FiltrationTable of Contents /SAFETY Precautions & Specifications Safety Precautions Safety PrecautionsInstallation For Hvac Installer onlySpecifications Intended Application for Ultra-Aire 135HCondensate Water Removal Ducting 5A Installing Duct CollarsElectrical Requirements 4A Lifting Condensate5D Ducting for Fresh Air Option Controls Ventilation Timer/Humidity Control Panel P/NCompressor Release & Noise Abatement Humidity/Fan Control Panel P/NVentilation Timer Humidity Control AdjustmentFan/Filter Switch 7E DEH 2000 Digital Controller WITH Fresh Air and DamperVentilation Schedule Setting the TimeAutomatic or Manual Mode Page 2A Install Instructions SpecificationsInstallation 2B WiringFor Hvac Installer and Homeowner Operation3H Damper Operation and Setting Ventilation 3E Setting Relative Humidity Set point3F Fan Setting and Operation 3G Fan On Fan Off Fan ProgramLow Pressure Control 3J Programming Notes3L Stop Start 3I Intermittent or Programmed VentilationUnit Test to determine problem ServiceTroubleshooting Technical DescriptionRefrigerant Charging Impeller Fan ReplacementCompressor/Capacitor Replacement Replacing a Compressor, Nonburn OutUA-135H With Humidity/Fan Control Wiring DiagramsUA-135H W/Ventilation Timer UA-135H With DEH 2000 Digital ControllerOptional Parts List DescriptionService Parts List ULTRA-AIRE 135H Dehumidifier Limited Warranty PO Box 8680 Madison, WI Phone 608-222-5301 Fax

UA-135H specifications

The Therma-Stor Products Group UA-135H is a cutting-edge unit designed for efficient humidity control in various settings, especially in residential and commercial environments. This product stands out due to its robust construction and innovative technology, making it a preferred choice for those looking to maintain optimal air quality.

One of the key features of the UA-135H is its high-capacity dehumidification ability. With a removal capacity of up to 135 pints per day, this unit is ideal for tackling dampness in basements, crawl spaces, and larger living areas. This impressive capacity allows for effective moisture management, which is crucial in preventing mold growth and maintaining a healthy indoor environment.

Technologically advanced, the UA-135H incorporates a powerful compressor and a high-efficiency fan that ensures rapid and uniform air circulation. This design not only aids in faster moisture extraction but also enhances the overall energy efficiency of the unit. The built-in hygrometer monitors the humidity levels in real-time, allowing for automatic adjustments to optimize performance and reduce energy consumption.

Ease of use is another highlight of the UA-135H. The unit features a user-friendly digital control panel, enabling users to set their desired humidity levels with precision. Additionally, the product is equipped with a continuous drainage option, allowing for hassle-free operation without the need for frequent emptying of the water tank.

Durability is a hallmark of the UA-135H, featuring a corrosion-resistant housing that ensures longevity even in challenging environments. The unit operates quietly, providing effective humidity control without disturbing the peace of your home or workplace.

Energy efficiency ratings further enhance the appeal of the UA-135H. It not only meets but often exceeds industry standards, translating to cost savings on energy bills. The unit is also designed for easy maintenance, with accessible filters that can be cleaned or replaced with minimal effort, ensuring optimal performance over time.

In conclusion, the Therma-Stor Products Group UA-135H is a reliable and efficient solution for humidity control. Its combination of high-capacity dehumidification, advanced technology, user-friendly features, and durable design makes it an excellent investment for maintaining a healthy indoor environment. Whether for residential or commercial use, the UA-135H promises effective performance and long-lasting reliability.
Top Page Image Contents