Heat & Glo LifeStyle FB-IN-S, FB-GRAND-S owner manual Lighting Appliance, Standing Pilot Ignition

Page 27

B. Lighting Appliance

Standing Pilot Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING

INSTRUCTIONS

1.Turn off all electric power to the appliance.

2.Push in gas control knob slightly and turn clockwise to “OFF”.

A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explo- sion.

D. Do not use this appliance if any part has been under water. Im- mediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

NOTE: Knob cannot be turned from “PILOT” to “OFF” unless knob is pushed in slightly. Do not force.

3.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the Safety Informa- tion located on the left side of this label. If you don’t smell gas, go to next step.

4.Find the pilot. The pilot is inside combustion chamber next to the main burner.

5.Turn knob on gas control counter clockwise

to “PILOT”.

6. Push in control knob all the way and hold in. Im-

mediately depress red or black piezo button. It may

require several depressions of the red or black

piezo button until PILOT lights. If PILOT light does

WARNING: CAUTION:

not light after 10 seconds, return to step 3. Continue to

hold the control knob in for about one minute after the

pilot is lit. Release knob and it will pop back out. Pilot

should remain lit. If it goes out, repeat steps 3 through 6.

DO NOT CONNECT 110 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, al- teration, service or maintenance can cause injury or property damage. Re- fer to the owner’s information manual provided with this appliance.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion which are known to the State of California to cause can- cer, birth defects, or other reproduc- tive harm.

Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.

Hot while in operation. Do not touch. Keep children, clothing, furniture, gaso- line and other liquids having flammable vapors away.

Do not operate the appliance with panel(s) removed, cracked or broken. Replacement of the panel(s) should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and propane. A conversion kit, as supplied by the manufacturer, shall be used to convert this appliance to the alternate fuel.

Also Certified for Installation in a Bedroom or a Bedsitting Room.

For assistance or additional informa- tion, consult a qualified installer, ser- vice agency or the gas supplier.

• If knob does not pop up when released, stop and im-

 

mediately call your service technician or gas supplier.

•

If the pilot will not stay lit after several tries, turn

 

the gas control knob to “OFF” and call your service

 

technician or gas supplier.

7.

Turn gas control knob counterclockwise to

“ON”.

8.To light Burner, flip the on/off switch to the “ON” position, and close access grille.

9.Turn on all electric power to the appliance.

TO TURN OFF GAS TO APPLIANCE

1. Turn off all electric power to the appliance if service is to be performed.

2.

Open control access panel.

3.

Move switch to “OFF” position.

4.

Push in gas control knob slightly and turn clock-

 

wise

to OFF”. Do not force.

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

5.

Close control access panel.

 

464-903G

Heat & Glo • FB-IN-S, FB-GRAND-S • 783-910 Rev. D • 3/08

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents FB-GRAND-S FB-IN-S ModelsHomeowner Reference Information CongratulationsTable of Contents Listing and Code Approvals Tools and Supplies Needed Design and Installation ConsiderationsGetting Started Inspect Appliance and ComponentsInches Millimeters Fireplace Size RequirementsMinimum Fireplace Opening LocationClearances to Mantels or other Combustibles above Appliance ClearancesFoot minimum in snow regions Termination LocationsVent Termination Minimum Clearances Fire Risk Asphyxiation RiskMeasuring Standards Vent Information and DiagramsVent Table Key Horizontal VentingInstallation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVenting Components Placing, Securing and Leveling the Appliance Damper Flashing Kit Optional Installing Adaptor and Termination CapMasonry Factory Built Wood BurningMinimum inlet pressure Gas InformationFuel Conversions Gas Connection Gas PressuresHigh Altitude Installations Appliance Requirements Wiring the ApplianceON/OFF Switch Electrical InformationShock hazard Junction Box InstallationInstallation for Fan Optional Optional AccessoriesFAN Junction BOX Installing Trim Surrounds FinishingMantel Projections Ember Placement Appliance SetupClean the Appliance AccessoriesLogs Locating Tabs Grate Assembly Heat & Glo FB-IN-S, FB-GRAND-S 783-910 Rev. D 3/08 Instructions Positioning the Logs Model FB-IN-SLOG PlacementFlat Spot for Log #4 Replacing Glass Assembly Glass AssemblyAir Shutter Setting Removing Glass AssemblyOperating Instructions Before Lighting ApplianceBefore operating this appliance have a qualified technician Standing Pilot Ignition Lighting ApplianceDo not operate appliance with glass door removed Initial Break-in ProcedureCheck Pilot Flame Appearance After Appliance is LitFrequently Asked Questions Troubleshooting Symptom Possible Causes Corrective ActionStanding Pilot Ignition System Troubleshooting Symptom Possible Cause Corrective ActionMaximum flame impingement. Follow lighting instruc Maintenance Tasks Maintaining and Servicing ApplianceRisk of injury or property damage Inspect Maintenance Tasks Reference Materials Appliance Dimension DiagramDirect Vent Flex Liner Kits Vent Kits ComponentsLog Set Assembly Service PartsPart number list on following At Depot Be ordered from an authorized dealerIncludes Pilot, Pilot Bracket and Air Passge Gaskets FB-IN-S NGKS-FBIN Stocked FB-GRAND-S, FB-IN-SLimited Lifetime Warranty Heat & GLO GAS Appliance Products Limited Lifetime WarrantyImportant operating Contact Information

FB-GRAND-S, FB-IN-S specifications

The Heat & Glo LifeStyle FB-IN-S and FB-GRAND-S are modern and innovative gas fireplace models that encompass style, comfort, and efficiency. Designed to enhance living spaces, these fireplaces provide both warmth and ambiance, making them a popular choice among homeowners and interior designers alike.

One of the standout features of these fireplaces is their sleek and contemporary design. The FB-IN-S model boasts a minimalist aesthetic that can seamlessly blend with various decor styles, while the FB-GRAND-S offers a more grand presence with its larger viewing area and elegant lines. Both models are constructed with high-quality materials that ensure durability and longevity, providing peace of mind for users.

In terms of technology, both fireplaces are equipped with advanced heating systems that deliver efficient warmth quickly and effectively. The high-performance burner design maximizes heat output while minimizing fuel consumption, resulting in lower energy bills and a reduced carbon footprint. Additionally, these models come with the unique IntelliFire ignition system, which allows for reliable and easy operation. With just the push of a button, users can enjoy instant warmth without the hassle of traditional wood-burning fireplaces.

The LifeStyle series also features customizable flame settings, allowing users to adjust the intensity and height of the flames to create the perfect ambiance for any occasion. The unique flame presentation technology creates a realistic and captivating fire display, enhancing the overall aesthetic of the living space.

Safety is a top priority for Heat & Glo, and both FB-IN-S and FB-GRAND-S models incorporate several safety features. The advanced safety shut-off system ensures that the fireplace operates safely and reliably, while the cool-to-the-touch glass front protects against accidental burns. Additionally, the fireplaces come with options for remote control operation, providing convenience and ease of use.

Another notable characteristic of these models is the wide range of venting options available, allowing for flexible installation in various home layouts. Homeowners can choose from direct vent or top vent configurations, making it easier to integrate the fireplace into any existing space.

In conclusion, the Heat & Glo LifeStyle FB-IN-S and FB-GRAND-S offer a perfect blend of style, technology, and safety. With their modern designs, efficient heating capabilities, customizable flame settings, and advanced safety features, these fireplaces are poised to enhance any home, making them a worthwhile investment for those seeking comfort and elegance in their living spaces.
Top Page Image Contents