Heat & Glo LifeStyle GEM36 manual Hole and Vent Pipe

Page 18

4. Install Firestops

For Horizontal Runs - Firestops are REQUIRED on both sides of a combustible wall through which the vent passes.

NOTE: Model DVP-TRAP does not need an exterior firestop on an exterior combustible wall.

To install firestops for horizontal runs that pass through either interior or exterior walls:

•Cut a 10-inch by 12-inch (254mm X 305mm) hole through the wall.

NOTE: The center of the hole is one (1) inch (25.4mm) above the center of the horizontal vent pipe.

•Position the firestops on both sides of the hole previ- ously cut and secure the firestops with nails or screws.

•The heat shields of the firestops MUST BE placed to- wards the top of the hole.

•Continue the vent run through the firestops.

NOTE: There must be NO INSULATION or other combustibles inside the framed firestop opening.

10"

INTERIOR

WALL SHIELD

12"

Figure 15. 10" x 12" Hole and Vent Pipe

HEAT SHIELD

TRIM HEAT SHIELD IF TOO LONG, ADD TO SHIELD IF TOO SHORT

EXTERIOR

FIRESTOP

INTERIOR

FIRESTOP

Figure 16. Heat Shield, Interior & Exterior Firestops

For Vertical Runs - One ceiling firestop is REQUIRED at the hole in each ceiling through which the vent passes.

To install firestops for vertical runs that pass through ceilings:

•Position a plumb bob directly over the center of the verti- cal vent component.

•Mark the ceiling to establish the centerpoint of the vent.

•Drill a hole or drive a nail through this centerpoint.

•Check the floor above for any obstructions, such as wir- ing or plumbing runs.

•Reposition the fireplace and vent system, if necessary, to accommodate the ceiling joists and/or obstructions.

•Cut an 10-inch X 10-inch (254mm X 254mm) hole through the ceiling, using the centerpoint previously marked.

•Frame the hole with framing lumber the same size as the ceiling joists.

10" (254mm)

10" (254mm)

 

 

CHIMNEY

 

HOLE

NEW

EXISTING CEILING

JOISTS

FRAMING

MEMBERS

 

CEILING

 

Figure 17. 10" x 10" Hole & New Framing Members

If the area above the ceiling is NOT an attic, position and secure the ceiling firestop on the ceiling side of the previously cut and framed hole.

NOTE: There must be NO INSULATION or other combustibles inside the framed firestop opening.

JOIST

CEILING

NAILS (4 REQUIRED)

CEILING FIRESTOP

Figure 18. Ceiling Firestop (Ceiling Side)

18

Heat & Glo • GEM36 • 370-900 Rev. O • 2/05

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Installers Guide What to do if you smell gasSafety and Warning Information Table of Contents Log set assembly GEM36Service Parts List / Liste des pièces de rechange GEM36Intermittent Pilot Ignition Valve Assembly Description Serial # Part Number Pièce DE Série DE PièceAppliance Certification Installation CodesHigh Altitude Installations CertificationPre-install Preparation Introducing the Heat & Glo Gas FireplacesANY Such Action MAY Possibly Cause a Fire Hazard Diagram of the GEM36 Constructing the Fireplace Chase Locating the FireplaceClearance Requirements Framing Dimensions Framing the FireplaceAT Each Joint Installing the Vent System Tems or Components MAY be UsedVertical Venting Pilot Shield AdjustmentFlue Restrictor Instructions MAX .4 MVenting with ONE 1 90 Elbow + H 1 FTTWO 2 90 o Venting with One 90 ElbowVenting with Three 3 90 Elbows + H 1 FTVenting Out the Top Vent Installing Vent ComponentsInstall Support Brackets Attach the First Vent Component to the Starting Collars12 Hole and Vent Pipe Vent Termination Attic FirestopPositioned SO That the Arrow is POINT- ING UP Vent Termination Minimum Clearances Positioning, Leveling and Securing the Fireplace Leveling and Securing of a FireplaceGas Control System Vice Must be Wired Directly to the FIRE- Place Junction BOXHeat-Zone Kit Intermittent Pilot Ignition SystemGas Supply Line Gas Pressure RequirementsPressure Natural Gas Propane Wiring the Fireplace Fan Wiring Diagram FinishingFacing Requirements Facing Thickness from 3/4 to 1-1/4Facing Thickness greater than 1-1/4 Installing Trim, Logs Ember Material GEM42 CeramicLighting the Fireplace After the InstallationBefore Lighting the Fireplace Climate ControlFireplace Maintenance Important Turn OFF the GAS Before Servicing Your Fireplace

GEM36 specifications

The Heat & Glo LifeStyle GEM36 is a stunning gas fireplace that harmoniously blends design, functionality, and technology. This contemporary vented fireplace is designed to be the centerpiece of any room, providing warmth while enhancing the aesthetic appeal of spaces ranging from modern living rooms to cozy dens.

One of the standout features of the GEM36 is its impressive viewing area. With a large glass front, this fireplace maximizes visibility, allowing you to enjoy the mesmerizing flames from various angles. The clear, clean lines of the design make it a perfect fit for any décor style, while the customizable options allow homeowners to personalize the look to match their preferences.

The GEM36 incorporates innovative technologies that enhance its performance and user-friendliness. One notable technology is the IntelliFire™ ignition system, which provides reliable and efficient operation. This system offers the convenience of remote control, making it easy to ignite the fire from a distance, ensuring a warm welcome every time you walk into the room.

In terms of efficiency, the GEM36 boasts an impressive heat output, ensuring spaces are not only stylish but also comfortable year-round. The adjustable flame height provides control over the ambiance, allowing users to create the perfect setting for any occasion. This efficiency is complemented by the advanced combustion technology designed to ensure cleaner burning and improved heat management.

Moreover, the LifeStyle GEM36 offers various decorative media options to suit individual tastes. Homeowners can choose from traditional log sets to modern glass or stone accents, allowing for a customized look that enhances the overall aesthetic of the fireplace.

Safety is also a priority with the GEM36, which incorporates features designed to minimize risk. The fireplace is equipped with safety sensors that monitor gas levels and ensure safe operation, providing peace of mind for users.

In summary, the Heat & Glo LifeStyle GEM36 is more than just a fireplace; it is a statement piece that combines elegance, innovation, and safety. With its impressive features, including IntelliFire™ ignition, customizable aesthetics, and high-efficiency performance, the GEM36 is an excellent choice for those looking to elevate their living spaces and enjoy the warmth and comfort of a gas fireplace.
Top Page Image Contents