E. Valve Access
•The gas valve can be accessed behind the cement refractory panel on the right side of the fireplace.
•Lift doors out and set aside. There is a washer under each door. Be careful not to loose those washers.
Washer
Figure 6.1 Lift Out Doors
•Remove logs if access is necessary after installation is complete. See Section 9.C. Remove logs in reverse order of set up.
•Remove grate if access is necessary after installation is complete. (Refer to Section 9.B.)
•Remove two screws on side of pilot shield and remove shield.
Figure 6.2 Remove Pilot Shield
•Use a phillips screwdriver to remove the two screws securing the refractory retaining strip. Remove the refractory side panel and set aside.
•Remove the inside valve access panel by lifting it up and out.
Figure 6.4 Remove Valve Access Panel
•Use a phillips screwdriver to remove the exterior valve access panel (remove four screws).
Figure 6.5 Remove Exterior Valve Access Panel
•Use a manometer on the lower out pressure tap. Start up the fireplace to verify the pressure and adjust as necessary. Reverse these steps to reassemble before log positioning.
Figure 6.3 Loosen Refractory Retaining Strip
Figure 6.6 Connect Manometer
12 | Heat & Glo LifeStyle Collection • Dakota |