Desa (V)gM36h, (V)gM42 Operation Maintenance Guidelines, Installing glass doors, Door Adjustment

Glass Door

Installation

Continued

Installing glass doors

Spring clips have been installed but some adjust- ments may be needed. Install the doors using the following steps:

1.With bi-fold doors completely folded, insert bottom pivot pin into pivot hole located near bottom corner of front face opening and swing door to vertical position making sure top pins slide into door track. Door is installed when top door pin snaps into spring clip.

2.Repeat step 1 for remaining door.

If you find the doors do not close properly or do not appear level or straight, proceed with section on door adjustment,

Fold Door	Spring
and Slide	Clip
Top Pins	Insert Pin
Into Track
	into Spring
	Clip

Insert

Bottom

Pivot Pin

into Hole

Pivot

Hole

Figure 28 - Installing Bi-Fold Doors

Door Adjustment

Remove doors and slightly loosen lower pivot clips and upper spring clips. Replace doors and fully close them. Use 1/8" shims (any material) to level doors. Once proper setting is achieved, carefully open doors enough so that you can access spring clips with a phil- lips screwdriver. Tighten screws. See Figure 29.

Figure 29 - Adjusting Bi-Fold Doors

Operation and

Maintenance Guidelines

Glass Doors

Glass doors are optional with the fireplace. When fireplace is in operation, doors must be fully opened or fully closed position only or a fire hazard may be created (see Figure 30).

A fireplace equipped with glass doors operates much differently than a fireplace with an open front. A fireplace with glass doors has a limited amount of air for combustion.

Excessive heat within the fireplace can result if too large a fire is built or if combustion air gate is not completely open. The following tips should be followed to assure that both the fireplace and glass door retain their beauty and function prop- erly. Both the flue damper and glass doors must be fully opened before starting fire. This will provide sufficient combustion air and maintain safe temperatures in firebox.

IMPORTANT: The glass must be allowed to warm slowly and evenly. The tempered glass will withstand a gradual temperature rise to 550° F, which is more than a normal fire will generate. Such materials as pitch/wax laden logs, very dry mill end lumber and large amounts of paper or cardboard boxes can create an excessively hot fire and should not be burned in this fireplace. Always keep the fire well back from the doors and never allow flames to contact the glass.

WARNING: Fireplaces equipped with glass doors should be operated only with doors fully opened or doors fully closed. Doors, if left partly open, may draw gas and flame out of the fireplace opening creating risks of both fire and smoke.

Doors Fully Closed

Fireplace Front

Fireplace Front

Doors

Fully Opened

Figure 30 - Bi-Fold Glass Doors

112435-01M www.desatech.com 23