Installation, Check GAS Type, Electrical Hookup

OWNER’S MANUAL

INSTALLATION

NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your pri- mary heating system. Do not in- stall this heater as your primary heat source. If you have a central heating system, you may run system’s circulating blower while using heater. This will help circu- late the heat throughout the house. In the event of a power outage, you can use this heater as your primary heat source.

WARNING: A qualified ser- vice person must install fireplace. Follow all local codes.

WARNING: Never install the fireplace

•in a bedroom or bathroom

•in a recreational vehicle

•where curtains, furniture, clothing, or other flammable objects are less than 42 inches from the front, top, or sides of the fireplace

•in high traffic areas

•in windy or drafty areas

CAUTION: This fireplace cre- ates warm air currents. These cur- rents move heat to wall surfaces next to fireplace. Installing fire- place next to vinyl or cloth wall coverings or operating fireplace where impurities (such as to- bacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls.

Use the dimensions shown for rough open- ings to create the easiest installation. See Built-In Fireplace Installation, page 9.

IMPORTANT: Vent-free heaters add mois- ture to the air. Although this is beneficial, installing fireplace in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Com- bustion and Ventilation, pages 4 through 6.

IMPORTANT: Make sure the fireplace is level. If fireplace is not level, log set will not work properly.

CHECK GAS TYPE

Use only propane/LP gas. If your gas supply is not propane/LP gas, do not install fire- place. Call dealer where you bought fire- place for proper type fireplace.

ELECTRICAL HOOKUP

(Models GA3700 Series and

GA3700T Series Blower

Accessories, and GA3555

Internal Duplex Kit)

This fireplace accepts a blower assembly with anelectricalcord.Theelectricalcordisfivefeet in length. You must locate fireplace within reach of a 120 volt grounded electrical outlet. If not, you must install an electrical outlet within reach of fireplace power cord. The GA3555 outlet accessory may be used for built-in appli- cations with blower accessory installed.

INSTALLING DEFLECTOR AND HOOD

1.Place deflector on top of exhaust shroud with triangular ends pointing out. Align hole in deflector with center hole in lou- ver panel.

Louver Panel

Exhaust

Shroud

Deflector

2.Slide the hood on top of the deflector and align the center hole with the holes in the exhaust shroud and louver panel.

3.Using Phillip’s head screw provided, insert the center screw through the hood, deflector, and louver. See Figure 5.

4.Secure the hood with the remaining 2 screws provided.

ASSEMBLING AND ATTACHING OPTIONAL BRASS TRIM (Included with Mantel Accessory or Purchased Separately)

IMPORTANT: If you are recessing the fire- box in a wall, do not attach brass trim at this time. See page 9 for built-in installation..

Note: The instructions below show assem- bling and attaching brass trim to fireplace.

1.Remove packaging from three pieces of brass trim.

2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 6.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 6).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 6).

6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

		Set Screws
	Side Brass	Top
	Side Brass	Brass
	Trim	Brass
	Trim	Trim
	Adjusting	Trim
	Plate

Note: Your fireplace is designed to be used in zero clearance installations. Wall or fram- ing material can be placed directly against any exterior surface on the rear, sides, or top of your fireplace, except where stand-off spacers are integrally attached. If stand-off

Hood

Slot

Shim

Slot

Mitered Edge

spacers are attached to your fireplace, these spacers can be placed directly against wall or framing materials.

Screws

Figure 5 - Installing Deflector and Hood

Figure 6 - Assembling Brass Trim

Continued

104637

VCGF30PR specifications

The Desa VCGF30PR is an advanced gas fireplace designed for both aesthetic appeal and functional efficiency. This model stands out in the market for its combination of modern technology, sleek design, and user-friendly features, making it an excellent choice for homeowners seeking an elegant heating solution.

One of the standout features of the VCGF30PR is its impressive heating capacity. Designed to warm spaces effectively, it can heat an area of around 1,200 square feet, making it ideal for living rooms, dens, and other large spaces in the home. The fireplace operates on natural gas or propane, providing flexibility depending on the homeowner's needs and preferences.

The unit boasts a stunning ceramic glass front, allowing for a clear view of the flames while minimizing heat loss. This design not only enhances the aesthetic appeal of the fireplace but also aids in energy efficiency. The use of advanced technology ensures that the flames are realistic and comforting, creating the perfect ambiance for any occasion.

One of the significant technological advancements in the VCGF30PR is its electronic ignition system. This feature enables quick and hassle-free startups with just the push of a button. The unit is also equipped with a built-in blower, which helps circulate warm air throughout the room, enhancing heating efficiency and comfort.

Safety is a priority with the Desa VCGF30PR. The fireplace includes a built-in safety shut-off valve that automatically cuts the gas supply in case of any irregularities, providing peace of mind for users. Additionally, it features a thermostat control, allowing homeowners to set their desired temperature for optimal comfort without constant monitoring.

The VCGF30PR also incorporates easy maintenance features. Its design allows for straightforward cleaning and upkeep, ensuring that it remains a captivating focal point in any home for years to come. The variety of finish options available—such as brushed nickel, black, or traditional bronze—allows homeowners to customize the look of their fireplace to match their interior décor.

In conclusion, the Desa VCGF30PR gas fireplace combines modern technology, safety features, and beautiful design elements, making it a remarkable addition to any home. With its efficient heating capabilities, user-friendly operation, and elegant appearance, it promises both comfort and style for years to come.