24
FIREPLACE INSTALLATION
Wall Switch Installation
Optional Remote Control Installation
WIRING DIAGRAM
FIREPLACE INSTALLATION
Continued
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace. Refer to wiring diagram below.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless
1.Open lower louver panel.
2.The WRC model receiver does not require a battery. The re- ceiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 47).
3.Activate the remote handset battery by removing the insulat- ing tab on the back of the handset (see Figure 48). The battery is included
4.Once the battery is activated the unit is ready to use.
5.Close lower louver panel.
Fireplace |
|
Receptacle | Remote Control |
| |
| Receiver |
Extension Cord | Ignition | |
Module Plug | ||
|
Figure 47 - Installing the WRC Remote Receiver
Battery Cover
12 Volt Battery
Back of | Pull to Remove | |
Handset | ||
Insulation Tab | ||
|
Figure 48 - Installing Battery into Back of Handset
WIRING DIAGRAM
| Pilot | |
| Burner | |
INCOMING MAIN | Pilot Gas | |
GAS SUPPLY | ||
| Line | |
| MV | |
| TH | |
EV1 | PV/MV | |
TR | ||
| ||
| GND | |
| PV | |
| IGN |
EV2
24V AC
STEP DOWN
TRANSFORMER
120V AC
GAS LINE TO
BURNER
WALL SWITCH
(NOT SUPPLIED)
ON | OFF |
BLACK | INCOMING |
| |
WHITE | 120V AC |
GREEN | (FUSE BOX |
OR BREAKER) |
BLACK | WHITE | GREEN |
ELECTRICAL RATING:
120v, 60Hz, 0.7A
OPTIONAL
REMOTE
CONTROL
For
.
.com
