FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these directions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance
•Do not touch any electrical switch, do not use any phone in your building
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department
Lighting Instructions
1.Turn the gas
2.Wait five (5) minutes to clear out any gas. If you then smell gas STOP! Follow the safety information on above. If you do not smell gas, go on to the next step.
3.Light a match and lay it on top of the pan material, about 2” from the end of the supply side of the pan. (Fig. 8)
4.Slowly turn the gas
Figure 9
LG176 | Match |
WARNING: Flame may flare up when ignited. Keep hands and face away from firebox.
Operation and Maintenance
To Adjust the Flame:
Adjust the flame to the desired level by rotating the gas
valve counterclockwise 
to open or clockwise 
to close.
To Turn the Appliance OFF:
Rotate the gas 
to OFF.
Proper Maintenance:
Keep the area around the log set clean and clear of debris.
Occasionally, you may use a soft bristle brush to clean logs.
Once every year, a qualified agency or certified chim- ney sweep should examine and clean the venting system of the fireplace in which the log set is installed.
Appliance Break-In
During the
To ensure proper curing of the logs:
1.Ignite a 2” flame and maintain it for 1/2 hour.
2.Burn the logs in consecutive 1/2 hour periods, raising the flame an additional 2” to full flame height for a total of three hours.
3311956 | 9 |