Tools Required

8” adjustable crescent wrench; pipe thread sealant compound or teflon tape; 12” pipe wrench or chan- nel lock pliers.

Gas Plumbed on Left Hand Side of Fireplace

NOTE: Your gas log set is assembled at the factory to be installed in a fireplace plumbed with the gas on the right side (facing). If your fireplace is plumbed with the gas on the left side, you may remove the u-burner tube from the burner pan by removing the 3/4” knockout at the left back of the burner pan and reinstalling the u-burner tube 180 degrees from its original position. You may also run a flexible connec- tor (or as per local codes) along the back wall of the fireplace to bring your gas line to the right hand side. You can then place the set in front of the flexible connector.

Damper Stop Installation:

For Use with BR, BC, SR, SC, TF and TL Series CFM Specialty Home Products Fireplaces

This Damper Stop is designed to work on all CFM Specialty Home Products BR, BC, SR, SC, TF and TL series fireplaces. For all other fireplaces, refer to Page 6.

When installing a decorative gas appliance in a fireplace, some local codes require this Damper Stop to be used so the Damper will not close completely. To install the Damper Stop:

The Damper Locking Bracket is already installed on all BR, BC, SR, SC, TF and TL fireplaces. Locate the Damper Locking Bracket on the left side of the fireplace’s Combustion Dome. (Fig. 1)

With the Damper open, align the two slots on either side of the cut-out on the Damper Stop with the two small holes on the angled portion of the Damper Locking Bracket. Attach the Damper Stop with the Screws provided, as shown in Figure 2.

NOTE: Some of the early fireplace units may not have the holes in the end of the Damper Locking Bracket. If this is the case, use the Damper Stop as a template to drill two (2) 1/8” holes in the Damper Locking Bracket to mount the Damper Stop.

Damper Locking Bracket	Damper Plate
Figure 1	DP100
Damper Locking
Bracket

Damper Stop Screw
Figure 3	Damper Stop	DP101

3311956