VENTING INSTRUCTIONS
CANADIAN INSTALLATIONS:
The venting system must be installed in accordance with the current
U.S.A. INSTALLATIONS:
The venting system must be installed in accordance with the current National Fuel Gas Code, ANSI Z223.1.
Minimum clearances to combustible materials is 1 inch (25
COMMON FLUE INSTALLATIONS
In some areas it is possible to vent more than one gas fireplace into the same flue. You must ensure that the flue being shared has the proper capacity to handle both fireplaces. Check installation codes for venting capacity information.
As always it is best to check with the authority having jurisdiction prior to commencement of the installation.
mm)for B Vent (Fig. 9, 11) and 6 inches for single wall vent (Fig. 10).
As with any natural drafted appliances, the vent cap must always extend a minimum of 2' above any structure within a 10' horizontal plane.(Fig. 8)
3' | 2' | 10' | 3' |
| 10' |
|
|
Fig. 8
VENTING OF THE RFS22/RFS32/RFS42
FIREPLACE
Note: Please refer to installation instructions supplied by chimney manufacturer prior to commencing installation.
Fig. 9 |
OFFSET B |
VENT CHIMNEY |
Fig. 10
EXISTING
MASONRY CHIMNEY
The RFS22/RFS32/RFS42 may be installed using 4" diameter single wall vent up to an existing masonry chimney.(Fig. 10) This vent should then be connected to a 4" liner running the full height of the chimney, as it is mandatory in most jurisdictions that the chimney be lined.
Another option is 4" "B" vent directly off the fireplace(Fig.9
&11), going up to the chimney liner or up through the roof if no chimney exists.
A minimum 12 foot vent height is required to effectively vent this fireplace.
Fig. 11
STRAIGHT B
VENT CHIMNEY
- 7 -