OPERATING INSTRUCTIONS
GENERAL GLASS INFORMATION
Only glass approved for use in The CFM Majestic Products Company products may be used for replacement.
1.The use of substitute glass will void all product warranties.
2.Care must be taken to avoid breakage of the glass.
Under no circumstances should this fireplace be operated without the front glass or with a broken glass. Replacement of the glass (with gasket) as supplied by the manufacturer should be done by a licenced qualified service person.
For the RFS42 both front bay window glass and rear window glass need to be installed for proper performance. Under no circumstance should this fireplace be operated without the rear window glass or with broken glass. Replacement of the rear glass (with gasket) as supplied by the manufacturer should be done by a licensed qualified person.
LOUVRE REMOVAL
RFS22
Remove the front louvre assembly by lifting up and outward on the assembly.
RFS32
To remove louvres first remove the two (2) screws (Fig. 13) fastening the louvre assembly to the fireplace. Lift the louvre assembly straight out sliding the back guides out of the fireplace body. (To reinstall, reverse).
RFS42
The top louvre is assembled with the Bay Window Frame and is not required to be removed.
Front View
Screws | Fig. 13 |
|
TRIM REMOVAL
RFS22
1.Remove frame window brass trim by lifting up and out.
2.Remove decorative cover, which was at the bottom of the frame window trim by loosening two (2) nuts on the underside of the cover.
RFS32
1.Remove the two (2) outer 3/8" nuts holding the frame window brass trim in place. (Fig. 14)
2.Remove the frame window brass trim by moving it straight forward.
RFS42
Remove trim Bay Window, top and bottom by pulling
them from the unit. They are held with magnets.
- 9 -
GLASS REMOVAL
RFS22
1.Remove frame window brass trim (See Trim Removal section)
2.Remove remaining bottom 3/8" nut at the bottom of the frame window.
3.Remove frame window by pulling it forward and up.
RFS32
1 . Remove frame window brass trim (See Trim Removal section)
2.Remove remaining bottom 3/8" nut fat the bottom of the frame window.
3.Remove 3/8" nut from each side of the frame window (Fig. 14).
4.Remove frame window by pulling it forward and up.
GLASS
FRAME
OUTER NUTS | DRAWING 2 |
DRAWING 1
Side Nuts
BOTTOM NUT | Fig. 14 |
|
RFS42
1 . Remove both Bay Window brass trims (See Trim Removal section).
2.Open two clamps underneath the Bay Window that holds the Bay Window Frame and Glass Frame. (Fig. 15)
3.Lift and unhook the Bay Window assembly at the top.
4.Lift and unhook the Glass Frame at the top.
| WINDOW |
| |
| FRAME |
| |
| PULL |
| |
PUSH | CLAMP HOOK | Fig. 15 | |
CLAMP HANDLE | |||
| |||