VENTED NATURAL GAS LOGS
INSTALLATION
Continued
INSTALLING THE EMBER
BED AND LOGS (Split Oak
Sets Shown)
1.Place the ember bed (included with burner set) over log grate as shown in Figure 18.
2.Position the back log flush against back of ember bed as shown in Figure 19.
3.Place the middle layer of logs as shown in Figure 20. Notice the grove in the back log for placement of log to the far right. Adequate space should be left between logs and ember bed for flames.
4.Place the top layer of logs as shown in Figure 21.
Ember Bed
Grate
Figure 18 - Installing Ember Bed
Figure 19 - Installing Back log
Figure 20 - Installing Logs
Figure 21 - Installing Logs
OPERATING
APPLIANCE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: Keep flue open when operating unit.
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.
BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
LIGHTING
INSTRUCTIONS
1.STOP! Read the safety information, above.
2.Turn the gas shutoff valve to OFF.
3.Wait five (5) minutes to clear out any gas. If you then smell gas STOP! Fol- low the safety information above. If you don’t smell gas, go on to the next step.
4.Light a match and lay it on top of the “U” shaped burner near the edge of the cover on the right side of the pan.
5.Slowly turn the gas shutoff valve ON until the burner ignites. If the burner doesn’t ignite within 10 seconds with the match burning, turn the shutoff valve OFF and repeat steps 1 through 4 again.
12 | 901846 |