Vermont Castings, Majestic Products, DEF33/36, DEFD33/36
Service Instructions
Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury.
Glass Frame Removal
NOTE: Applicable only to units with fixed glass door.
1.Turn off electrical supply to unit.
2.Let fireplace cool if it has been operating.
3.Open access panel Radiant.
4.Remove two door retention screws along lower sides edge of door frame.
5.Swing lower portion of door out from the fireplace and gently lift up to disengage top of door from fireplace (Fig. 6).
6.To reinstall glass door, follow the above procedure in reverse.
Glass /
Frame
Fireplace
Front
Retaining 
Screws
Window
Frame
Window
Frame
Screws 
FP1204
Fig. 6 Window frame assembly removal
Replacing Light Bulbs
This fireplace uses three (3) clear 120 Volt, 60 Watt,
Do not exceed 60 Watts per bulb. Use of higher rated bulbs may result in a fire, causing property damage, personal injury or loss of life.
1.Turn off power to the unit.
2.Allow fireplace to cool if it has been operating.
3.Remove glass door (refer to "Glass Frame Removal" section), or open glass doors.
4.Remove the four (4) screws securing the ember bed in position. Two screws (2) are located on either side of the ember bed near the front.
5.Examine the bulbs to determine which bulbs need to be replaced.
6.Hold the socket steady while unscrewing the defective bulb(s).
7.Install the new light bulb(s); hold the socket steady while screwing in.
8.Reinstall ember bed, log set, and glass door.
Cleaning Brass Trim
Clean the brass trim using a soft cloth, slightly dampened with lemon oil, then buff with a clean soft cloth. Do NOT use brass polish or household cleaners, as these products will damage the brass trim. Lemon oil can be obtained at supermarkets or hardware stores.
Glass Information
1.Under no circumstances is this product to be operated with missing or broken glass.
2.Do not strike or slam the glass.
3.Do not use abrasive cleaners to clean the glass.
4.Tempered glass is used in this product. A qualified service person must perform replacement of the glass with gasket, as supplied by the manufacturer.
Maintenance of Motors
The motors used on the fan and the drum assembly are prelubricated for extended bearing life, and require no further lubrication. However, periodic cleaning/ vacuuming of the fan/heater is recommended.
Make sure that the power is turned OFF before proceeding.
8 | 10005898 |