Vermont Castings, Majestic Products, DEF33/36, DEFD33/36
Operating Instructions
The control compartment is located behind the panel access Radiant. To access the controls, simply flip down the panel access Radiant. Refer to Fig. 8, below, to locate the position of each control.
1. Main ON/ OFF Switch
The ON/OFF switch supplies power to all functions of the fireplace. This is an illuminated switch that normally lights up when in the ON or OFF position.
During any service of this appliance, the power to the unit must be turned off. It is not acceptable to use the ON/OFF switch to meet this requirement.
2. Heater Control
The Heater Control acts to turn the heater ON and OFF as well as setting the comfort level in the room. Turning the knob clockwise from the OFF position will place the heater into operation. The further the knob is rotated clockwise, the higher the set point temperature. Turning the knob
3. Flame Speed Control
Turn the flame speed control knob to increase or decrease the flame speed as desired.
Control Panel
3 | 2 | 1 | 5 | 4 |
See Installation Instructions for service |
|
|
| |
details. |
|
| RED | |
WARNING: Disconnect Power Before |
|
| ||
|
|
| ||
Servicing. |
| GOLD | GOLD | |
WARNING: Risk of fire, keep electrical | GOLD | |||
|
| |||
cords, draping, and other furnishings at |
|
|
| |
least 3 feet (0.9m) from the front of the |
|
|
| |
heater. |
|
|
|
Voir les instructions d'installation pour des details sur le service. AVERTISSEMENT: Debrancher la source d'alimentation avant le service. AVERTISSEMENT: Risque d'incendie, veiller a ce que les cordons electriques, tentures et autres textiles domestiques soient a au moins 3 pieds (0,9m) de I'avant de I'appareil de chauffage.
LEARN
ON/OFF
10005509
FP1210
Fig. 8 Control panel
4. Re-learn
This model fireplace with integral remote control has a preprogrammed,
It is highly unlikely that the fireplace code will ever need to be
1.Be sure there is power to the fireplace.
2.Be sure there is a good battery in the Transmitter
3.Open the battery compartment of the remote.
4.Press and release the small button located in the top left corner. This will randomly select a new house code in the remote Transmitter.
5.Close the remote Transmitter battery compartment.
6.Press either the ON or OFF button on the Remote Transmitter, and the Learn button on the fireplace at the same time. The fireplace is now ready to accept commands from the remote Transmitter.
5. ON/OFF
The ON/OFF button on the fireplace (below the Learn button) is to turn the fireplace ON and OFF when the battery in remote Transmitter is weak, or to manually operate the fireplace without the remote Transmitter.
NOTE: The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and;
2.This device must accept any interference received, including interference that may cause undesired operation.
10005898 | 11 |