Maintenance
clockwise.
12.Replace light filter bracket and flicker rod.
13.Install the log set assembly by placing the front, bottom edge of the ember bed in the track behind the control panel. Once in place, push down on the back edge of the ember bed until the rear tab snaps into place under the mirror (Figure 8).
!NOTE: Ensure the log set
Assembly is installed tightly under the bottom edge of the mirror to prevent light leakage.
14.Lay unit on it’s back and slide Front Glass back into position
and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs with an
Do not exceed 25 Watts per bulb.
To access the upper light bulb area:
1.Slide fireplace out of mantel.
2.Lay unit on it’s back for safe removal of front glass.
3.Remove three (3) Phillips screws from right side of trim.
4.Remove trim.
5.Slide glass to the right side
Figure 9 | Light Block screws (4) |
| Light Block |
Flicker Rod | Light Filter |
| Bracket screws (2) |
| Lower Light |
| Bulbs (3) |
| 15 |