Dimplex BLF50 owner manual Install using screws removed in steps

Fireplace Installation

screws which hold the junction box to the fireplace chassis (Figure 6).

8.Pull the junction box and power cord out the front of the fireplace.

9.Replace removed junction box cover with the supplied hard-wire cover replacement

(Figure 7) and install using screws removed in steps 6

Figure 7

Hole for

Ground Screw

and 7.

10.Leaving a minimum of 3" (7.6 cm) of slack, route the power supply through the hole in the alternate junction box cover and secure with a wire clamp (not supplied).

11.Connect the black wire (live) from the unit to the black wire from the power supply using one of the wire connectors removed in step 5 (Figure 8).

12.Connect the white wire

(neutral) from the unit to the

Figure 8

Wires to

Black livecontrols wires

White neutral wires

white wire from the power supply using the second wire connector from step 5 (Figure 8).

13.Attach green grounding wire to hard wire cover cover with provided grounding screw.

Place wire in-between screw and lock washer and tighten.

14.Reposition the electrical box cover over the wires and connectors and attach to fireplace chassis using the screw removed in step 3.

15.Carefully reinsert partially reflective glass into fireplace and anchor in place using glass brackets and screws removed in step 1.

11