Dimplex BLF50 owner manual Remote Control Initialization/ Reprogramming, Remote Control Usage

Operation

Remote Control

The fireplace is supplied with a radio frequency remote control. This remote control has a range of approximately 50 feet (15.25 m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one

of hundreds of independent frequencies to prevent interference with other units.

!NOTE: Before attempting any operation with the remote, pull the plastic insulator strip out from between the remote casing and battery cover (Figure 19).

Remote Control Initialization/ Reprogramming

If the remote control or remote control receiver has been replaced, follow these steps to initialize the remote control and receiver:

1.Ensure that power is supplied through the main service panel.

2.Turn On/Off Switch to On (Figure 18A).

3.Move the 3-Position Switch to the “ REMOTE ” position (Figure 18B).

Figure 19

On

Button

Off

Button

Plastic strip

Battery cover

4.Press and hold the Manual

Control Button marked “ I ” for five (5) seconds. After five (5) seconds, there is a 10 second window to press any button on the remote control.

5.Press any button on the remote control within that 10 seconds.

This will synchronize the remote control and receiver.

Remote Control Usage

The remote control operates the fireplace levels sequentially (from off): flames only; to flames and low heat; to flames and high heat.

The level is increased every time the ON button is pressed on the remote control and the fireplace can be turned off at any point by pressing the OFF button.

19