Austro Flamm G3 manual Technical Data, Important Information, Setting Up Your Stove

G3 4 english

1. TECHNICAL DATA

As a stove of construction type 1, it is possible to connect it to the flue pipe of an existing other stove or another hearth for solid fuels, as long as the chimney complies with DIN 4705, Part 3.

TECHNICAL DATA

Height	793 mm
Width	453 mm
Depth	510 mm
Weight	120 kg
Weight with ceramic shell	170 kg
Flue pipe outlet diameter	130 mm
Nominal thermal output EN 13240	6 kW
Maximum thermal capacity	8 kW
Smallest heating capacity	3 kW

Room heating capacity (depending on 48–124 m³ building insulation)

Exhaust values for multiple use of the chimney in accordance with DIN 4705, Part 3 and for the calculation of the chimney measurements in accordance with DIN 4705, Part 2

Fluegas mass flow	closed	7 g/s
Fluegas temperature	closed	380 °C
Minimum feed pressure	closed	12 Pa
Nominal thermal output
	at 0.8 times	10 Pa
	n. ther. outp.

2. IMPORTANT INFORMATION

The installation and operation information given here is of general nature. National and European standards, local and building regulations as well as fire prevention laws must be observed during the operation of the stove.

General safety instructions for the operation of your stove

•Thoroughly read the entire manual before starting up your stove and observe the caution notices.

•Your heating unit may not be moved without approved means of transport with sufficient load- bearing capacity.

•Your heating unit is not suitable to be used as a stand or as a ladder.

•The burning of fuel releases thermal energy that leads to a substantial heating up of the surface of the heating unit, the doors and operating handles mounted on the door, door glass, flue pipe and in some cases the front wall of the heating unit. Do not touch any of these surfaces without respective protective clothing or without the help of accessories such as heat-resistant gloves or a cold hand.

•Make your children aware of this particular danger and keep them at a distance from the heating unit whenever it is in operation.

•Only burn approved fuels and materials listed in the chapter “Clean Burning”.

•The burning or placing of flammable or explosive materials, such as empty spray cans and such like into the firebox as well as the storage of such materials in the immediate vicinity of your heating unit is strictly forbidden due the danger of explosion.

•Do not wear loose or flammable clothing when adding fuel to the fire.

•Placing non-heat-resistant objects on the heating unit or in the vicinity of the heating unit is forbidden.

•Do not lay laundry onto the stove for drying. Laundry hung up to dry must be kept at a safe distance from the stove because of the danger of fire.

•The woodstove G3 is not suitable for long term heating.

•During the operation of your heating unit it is forbidden to use flammable or explosive materials in the same or an adjacent room to the one in which your heating unit is located.

•

Setting Up Your Stove

Required safety distances (Minimum

distances – see name plate - in Fig. 2)

1.to nonflammable objects:

a > 400 mm b > 200 mm c > 300 mm

2.to flammable objects and to supporting walls of reinforced-concrete construction with convection shell:

I - a > 800 mm b > 200 mm c > 300 mm II - a > 800 mm b > 300 mm c > 300 mm

III- a > 800 mm b > 500 mm c > 300 mm I = with stainless steel cladding

II = with convection cladding

III = without convection cladding

(a – toward the front in the radiated area) (b – to the side) (c – to the back)

Make sure that the room in which the stove is set up has at least one door or window into the outside or is directly adjacent to such a room. Other fireplaces and extractor hoods must not be operated in the same room as the stove.

Subject to technical and optical modifications. Formatting and printing errors excepted.