Turn the control knob gradually to your desired setting. Both burners should gradually increase in output until at MAX position the main burner is at its greatest heat output and the decorative flames are at their full magnitude.
2.5 To turn off
2.5.1 To turn the main and decorative flames off but leaving the pilot alight, depress the control knob partially, turn clockwise to IGN and release the knob. If any resistance is felt at position 1 when turning, release the downwards pressure on the knob before continuing to turn.
2.5.2 To turn the pilot off, depress the control knob at the IGN position, turn clockwise to OFF and release the knob.
3. CLEANING
All cleaning should be carried out when the fire is cold. Normally, the fire should only need dusting. Any stains on the glass can be removed with a non abrasive cleaner such as a ceramic hob cleaner. Abrasive cleaners should never be used.
3.1 To clean the inside of the window.
3.1.1 Detach the case front by removing the knurled screws and washers at the case sides (see figure 1).
3.1.2 Pull the bottom of the case forwards and then lift to remove.
3.1.3 Remove the window unit by detaching the 12 wing nuts securing the frame (see fig. 4) and pulling forward.
3.1.4 Clean the window carefully using a suitable cleaner in accordance with the instructions supplied with the cleaner.
3.1.5 Replace the window unit ensuring that the seal around the frame is not damaged or misplaced. Secure with the 12 wing nuts tightening them evenly.
3.1.6 Replace the case front.
3.2 Cleaning the coal pieces
If for any reason the coal pieces require cleaning, proceed as follows:- 3.2.1 Remove the case front and window as described above.
3.2.2 Carefully lift the coal pieces out of the firebox and place them on a piece of cardboard or similar.
3.2.3 Carefully clean the upper and lower surfaces of the coals with a soft brush or vacuum using a soft brush attachment.
3.2.4 Replace the coal pieces as described below.
3.3 Replacing the coal pieces
3.3.1 Place the fuel bed (embossed 'A' underneath) in position. The front edge of the fuel bed locates under the flange of the locating strip at the base of the firebox. See figure 5.
5