Weber 98583 Install Swing Table, MWARNING The load limit for the swing table is 30 pounds

Step 21

Install Swing Table

You will need: swing table assembly, support rod, support rod holder and swing table end bracket.

Insert the ends of the support rod through the lower keyholes in the swing table. Figure 27 (a). Slide until the tabs on the support rod pass through the keyholes. Figure 27 (b). To keep the support rod in place, rotate the rod so the tab is not lined up with the keyhole. Figure 27 (c).

Lower keyhole

(a)	Support rod
	(b)

(c)

Figure 27

Insert one end of the hinge rod into the hole in the frame. Figure 28 (a).

Insert the other end into the hole in the swing table end bracket. Figure 28 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 28 (c).

To fully seat the bracket, you may have to tap it lightly with a hammer.

mWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part.

Install support rod holder on leg. Figure 28 (d). Hook the support rod into the support rod holder.

mWARNING: The load limit for the swing table is 30 pounds.

Hinge rod

(a)

(b)

View from rear

of barbecue

Slot in frame (view from below)

(c)

(d)

Figure 28

20