Weber 98583 owner manual Safe handling tips for LP Gas, Liquid Propane LP Tanks

Page 27

Safe handling tips for LP Gas

■Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder, LP gas is a liquid. As the pressure is released the liquid readily vaporizes and becomes gas.

■LP gas has an odor similar to natural gas. You should know this odor.

■LP gas is heavier than air. Leaking LP gas may collect in low areas that prevent dispersion.

■To fill, take the LP tank to an RV center, or look up gas-propane in the phone book for other sources of LP gas.

mWARNING: We recommend that your LP tank be filled at an authorized LP gas dealer, by a qualified attendant, who fills the tank by weight. IMPROPER

Liquid Propane (LP) Tank(s)

■The LP tank and connections supplied with your Weber Gas Barbecue have been designed and tested to meet government, American Gas Association and Underwriters Laboratories requirements.

■Replacement LP tanks supplied by Weber satisfy the requirements. Check to be sure the tank has a D.O.T. certification, and has been tested within five years.

Your LP gas supplier can do this for you. Figure 7.

If you have questions about spare LP tanks, please call Weber-Stephen Customer Service.

D.O.T. Certification (example)

DOT 4BA240

FILLING IS DANGEROUS.

mWARNING: If you exchange your LP tank, make sure you get a similar tank in return. Your LP tank is equipped with a quick-disconnect valve and an OPD (Overfilling Prevention Device). Other LP tanks are not compatible with your barbecue connection.

20 lb LP tank

1/97

Date Tested

■Air must be removed from a new LP tank before the initial filling. Your LP dealer is equipped to do this.

■The LP tank must be installed, transported and stored in an upright position. LP tanks should not be dropped or handled roughly.

■Never store or transport the LP tank where temperatures can reach 125° F (too hot to hold by hand - for example: do not leave the LP tank in a car on a hot day).

Note - A refill will last about 20 hours of cooking time at normal use. The fuel scale will indicate the propane supply so you can refill before running out. You do not have to run out before you refill.

■Treat "empty" LP tanks with the same care as when full. Even when the LP tank is empty of liquid there still may be gas pressure in the cylinder. Always close the tank valve before disconnecting.

■Do not use a damaged LP tank. Dented or rusty LP tanks or LP tanks with a damaged valve may be hazardous and should be replaced with a new one immediately.

■The joint where the hose connects to the LP tank must be leak tested each time the LP tank is reconnected. For example, test each time the LP tank is refilled.

■Be sure the regulator is mounted with the small vent hole pointed downward so it will not collect water. This vent should be free of dirt, grease, bugs etc.

Figure 7

■All LP tank supply systems must include a collar to protect the tank valve.

■The LP tank must be a 20 lb size (18 1/4 inches high, 12 1/4 inches in diameter).

■The LP tank must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (D.O.T.).

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Spirit 700 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageAssembly Check package contentsStep REB Check contents of hardware packs Assemble top frame Assemble wheel frameContinue frame assembly Install tubing plugsAdd front panel Add cooking box Install manifold bracket Install igniter Add fuel scale assemblyMCAUTION Do not remove adjustment wing nut from tank scale Set LP fuel scaleFill LP tank Connect LP tank Check that all burner valves are offCheck for gas leaks MWARNING Do not ignite burners when leak checkingInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMWARNING The load limit for the swing table is 30 pounds Install Swing TableComplete accessory installation To Extinguish LightingManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseConnecting the filled LP tank Refilling the LP tankRemoval of the LP tank Male fitting Regulator Liquid Propane LP Tanks Safe handling tips for LP GasAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMWARNING Do not ignite burners while leak checking Weber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure MCAUTION Do not enlarge the burner ports when cleaningTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionPage 12-13 Parts List Final Word Thanks

98583 specifications

The Weber 98583 is a highly regarded grill cover designed to enhance the durability and longevity of your Weber gas grill. Engineered specifically to fit various models, this cover stands out for its exceptional construction and user-friendly features.

One of the main characteristics of the Weber 98583 is its heavy-duty material. Made from a high-quality, weather-resistant fabric, this cover provides robust protection against the elements. From intense sunlight to heavy rain and snow, it shields your grill from UV rays, fading, and moisture, ensuring that it remains in pristine condition over time. The material is also breathable, preventing moisture buildup that can lead to mildew and corrosion.

Another standout feature is the fitted design of the cover. It is tailored to snugly fit Weber gas grills, minimizing the chance of it blowing away in windy conditions. The precise fit not only enhances its aesthetic appeal but also adds to its protective capabilities, keeping dust, dirt, and debris at bay.

The Weber 98583 is equipped with convenient fastening straps that further secure the cover in place, making it ideal for outdoor use in varying weather conditions. These straps and the elastic hem cord provide a customizable fit, ensuring that the cover remains tightly secured around the grill.

In terms of maintenance, the Weber 98583 requires minimal care. Its durable fabric is easy to wipe clean, and the waterproof nature ensures that it doesn't absorb water. For deeper cleaning, it can simply be rinsed with a garden hose and air-dried, maintaining its functionality without extensive effort.

Additionally, the design of the Weber 98583 incorporates ventilation openings that prevent wind lofting and allow moisture to escape. This thoughtful design feature contributes to a longer lifespan for your grill, as it reduces the risk of rust formation.

In summary, the Weber 98583 is a top-quality grill cover that effectively combines protection, durability, and user-friendly features. Its heavy-duty material, snug fit, fastening straps, and ventilation openings make it an essential accessory for any Weber gas grill owner looking to safeguard their investment while enjoying outdoor cooking for years to come. Whether it’s rain, snow, or sunlight, the Weber 98583 ensures that your grill remains protected and ready for your next barbecue.
Top Page Image Contents