Regency MX Excel owner manual Blade Attachment

Page 11

BLADE ATTACHMENT

BLADE ATTACHMENT:

1.Place fiber washer on screw. Insert this assembly through the blade and start the screw into the blade arm. Repeat this procedure without tightening the screw until all 3 screws have been started into the blade arm (Fig. 4).

NOTE: Fans that have painted finishes are packed with gaskets that can be used between the blade arm and blade to help prevent a clicking noise that may develop if blade screws loosen over time.

2. Tighten each screw starting with center screw.

3Fasten blade assembly to motor with provided screws and metal lockwashers. Repeat procedure for remaining blades (Fig. 5). Make sure screws are TIGHT! Loose motor screws can contribute to unnecessary hum during oper- ation.

NOTE: Cordless power screw- drivers are NOT recommended, as they tend to strip the heads of the screws and usually will not fully compress the lock washers on the motor screws. Use a large flat blade screwdriver for final tightening to fully compress the washers. This will help ensure proper alignment of the blades and noise-free, wobble- free running.

Fig. 4

Fig. 5

9

Image 11
Contents Style that revolves around you Important Safeguards General Installation & Operation InstructionsTools and Materials Required Important Safety PrecautionsUnpacking Your FAN Preparation Installing the Mounting BracketHugger Mounting ˝ Downrod Mounting Installing the FANInstalling the FAN Hugger Style Installing the FAN with a Downrod Installing the FAN with a Downrod Electrical Connections Blade Attachment Installation of Removable Switch Housing Operation Troubleshooting in Case of DifficultyCare and Cleaning