Lopi Freedom Bay Fireplace Insert owner manual Features & Specifications

Page 6

6

Features & Specifications

Installation Options:

Masonry Fireplace Insert

WARNING: Do not install this fireplace insert into a factory-built metal (Z.C.) fireplace.

Features:

EPA Phase II Approved

3.1 Cubic Foot Firebox Volume

Single Operating Control

Accepts Logs Up to 24" Long

Steel Plate Construction (5/16" & 3/16")

Heavy Duty Refractory Firebrick

High-Tech Blower

Heating Specifications:

Approximate Maximum Heating Capacity (in square feet)*

1,200 to 2,250

Maximum BTU's per Hour (Cord Wood Calculation)

74,300

Overall Efficiency (Oregon Method)

70 %

Maximum Burn Time

Up to 12 Hours

*Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also affected by the quality and moisture level of the fuel.

Dimensions:

Measure side clearances

6" Diameter Flue

from the side of the insert.

 

5-5/8" 29-1/4"

20-1/4"

Measure top clearances from

the top plate.

Weight = 470 Lbs.

21-3/4"

Electrical Line (may be attached to the opposite side)

43-3/4"

15-3/4"

 

Measure front clearances

4-3/4"

 

from the faceplate.

Fireplace Opening

 

 

Faceplate

Figure 1

Emissions:

2.6 Grams Per Hour (EPA Phase II Approved) – Tests conducted by E.E.S.P.C.

© Travis Industries

100-01163

4041129

Image 6
Contents Freedom Bay Fireplace Insert Mail your Warranty Card Today, and Save Your Bill of Sale 2IntroductionIntroduction Important Information Table of Contents Safety Precautions AshesTravis Industries, Inc. grants no warranty, implied or MobileFeatures & Specifications Additional Accessories Needed for Installation Planning The InstallationPreparation for Installation Installation ConsiderationsMinimum Fireplace Size Fireplace RequirementsInsert Placement Requirements Hearth RequirementsMasonry Fireplace Requirements Leveling Bolt Installation Blower InstallationDrafting Performance Block-Off Plate Installation Block-Off Plate TemplateInsert with Positive Connection Insert with Direct ConnectionInsert with Face Seal Connection Before Your First Fire Safety NoticeOperating Your Appliance Opening the DoorBypass Operation Starting a Fire Adjusting the Burn Rate Approximate Air Control SettingsAsh Removal Overnight Burn Blower OperationRe-Loading the Stove Normal Operating SoundsHints for Burning Testing Wood MoistureWhy Dry Wood is Key Selecting WoodTroubleshooting Maintaining Your Appliance Daily Maintenance while stove is in useClean the Glass if necessary Remove Ash if necessaryMonthly Maintenance while appliance is in use Door and Glass InspectionCreosote Formation and Need for Removal Touch Up Paint Yearly MaintenanceCleaning the Air Duct and Blower Firebrick and Baffle InspectionReplacing the Door Gasket Door PartsReplacing the Glass Replacing the Door HandleFirebox Parts Floor and Side FirebrickBaffle Removal & Replacement Air Tube Removal & ReplacementYears 3 Through 5 Coverage Parts & Labor Limited 7 Year WarrantyYears 1 & 2 Coverage Parts & Labor Years 6 & 7 Coverage Parts onlyListing Label Listing LabelDoor Shell Installation Optional EquipmentSocket Side Frame Required only for face seal installations Installation InstructionsInsulation Installation Surround PanelsIndex