Majestic STR42, CVR42 Installing the Chimney System, Installing the Firestop Spacer Ceiling Hole

STR/CVR Series Woodburning Fireplaces

Installing the Chimney System

Start by attaching the first chimney section to the collar on top of the fireplace.

Install the pipe as pictured in Figure 16. When you get a good lock, you will hear the pipe clearly snap together. Once sections are snap-locked in place, it is extremely difficult to get them apart. Make sure the pipe is firmly snapped and locked together as each pipe section is mounted.

When installing elbows, only outer pipe will snap- lock. Middle pipes simply slide into position. Be sure to always attach straps on upper elbow to a structural framing member. (Fig. 17)

Continue installing the pipe as required until pipe is installed up through the ceiling. At this point, you must install a firestop spacer. Refer to Figure 18 for appropri- ate spacer orientation.

Installing the Firestop Spacer

in the Ceiling Hole

A firestop spacer is used to keep pipe spaced properly and required for safety.

Nail the firestop spacer (at each corner) to the framing members of the ceiling hole. NOTE: A firestop spacer is not required at the roof.

Hole sizes listed in Figure 12 for angled firestop spac- ers provide minimum required air space to chimney pipe for ceiling thickness up to 8" (203mm). When combined thickness of ceiling material, ceiling joists and flooring material exceeds 8" (203mm), adjustments must be made in framing to assure that minimum air spaces to chimney are maintained.

Proper Firestop Spacer Installation

Figure 18 shows different installation procedures for both an area that is an attic and an area that is not an attic.

Pipe Section

Pipe Rim

Hem

Lance

Pipe

Rim

FP711

Fig. 16 Install pipe, listening for the snap-lock to fasten.

Elbow Strap Support Structure

Elbow Strap (must be tight)

Ceiling Hole Fram- ing

Angled Strap	Angle Firestop
	Chimney Support
	Strap
FP270/271	(must be tight)

Fig. 17 Attach straps to a structural framing member.

If the area above the ceil- ing is not an attic, posi- tion the firestop spacer with the flange on the ceil- ing side and the angled portion extending up into the hole.

If the area above the ceiling is an attic, position the firestop spacer with the flange on the top of the framed hole and the angled portion extending down into the hole.

12

	Attic Installation	Ceiling Installation
		Nails (4)
		Joist
		Firestop
		Spacer
		Firestop
		Spacer
		Joist
		Nails (4)
FP593
Fig. 18	Installing firestop spacer.
		7412961