Operation and Care of Your Appliance

Maximum manifold pressure is 3.5 in. w.c. (0.87 kPa) for natural gas and 10 in. w.c. (2.49 kPa) for LP/Propane gas.

Do not use these appliances if any part has been under water. Immediately call a qualified, profes- sional service technician to inspect the appliance and to replace any parts of the control system and any gas control which have been under water.

Ne pas se servir de cet appareil s'il a été plongé dans l'eau, complètement ou en partie. Appeler un technicien qualifié pour inspecter l'appareil et remplacer toute partie du système de contrôle et toute commande qui ont été plongés dans l'leau.

Test gage connections are provided on the front of the millivolt gas control valve (identi- fied OUT for the manifold side and IN for inlet pressure.

Minimum inlet gas pressure to these appli- ances is 5.0 inches water column (1.24 kPa) for natural gas and 11 inches water column (2.74 kPa) for propane for the purpose of input ad- justment.

Maximum inlet gas supply pressure to these appliances is 10.5 inches water column (2.61 kPa) for natural gas and 13.0 inches water column (3.23 kPa) for propane.

The appliance must be isolated from the gas supply piping system (by closing its individual manual shut-off valve) during any pressure test- ing of the gas supply piping system at test pressures equal to or less than ¹⁄₂ psig (3.5 kPa).

The appliance and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of that system at pressures in excess of ¹⁄₂ psig (3.5 kPa).

These appliances must not be connected to a chimney or flue serving a separate solid fuel burning appliance.

Any safety guard or screen removed for ser- vicing the appliance must be replaced prior to operating the appliance.

WARNING: FAILURE TO COMPLY WITH THE INSTALLATION AND OP- ERATING INSTRUCTIONS PROVIDED IN THIS DOCUMENT WILL RESULT IN AN IMPROPERLY INSTALLED AND OP- ERATING APPLIANCE, VOIDING ITS WARRANTY. ANY CHANGE TO THIS APPLIANCE AND/OR ITS OPERATING CONTROLS IS DANGEROUS. IM- PROPER INSTALLATION OR USE OF THIS APPLIANCE CAN CAUSE SERI- OUS INJURY OR DEATH FROM FIRE, BURNS, EXPLOSION OR CARBON MONOXIDE POISONING.

Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea. If you have these signs, obtain fresh air imme- diately. Turn off the gas supply to the appli- ance and have it serviced by a qualified profes- sional, as it may not be operating correctly.

WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OFHIGHSURFACETEMPERATURES.USE CAUTION AROUND THE APPLIANCE TO AVOID BURNS OR CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CARE- FULLY SUPERVISED WHEN THEY ARE IN THE SAME ROOM AS THE APPLIANCE.

WARNING: DO NOT PLACE CLOTH- ING OR OTHER FLAMMABLE MATERI- ALS ON OR NEAR THIS APPLIANCE.

AVERTISSEMENT: SURVEILLER LES ENFANTS. GARDER LES VÊTEMENTS, LES MEUBLES, L'ESSENCE OU AUTRES LIQUIDES À VAPEUR INFLAMMABLES LOIN DE L'APPAREIL.

For piezo ignitor location, refer to Figure 1.

The control compartment is located behind the bottom front face piece. For access:

In the Cast Iron Face accessory - simply lift up and pull directly out.

In the Rectangular or Arched Face accessory - Pivot the main face door (bottom) on the two hinge pins, and drop down to open.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Honeywell

Gas Valve

Piezo

Ignitor

Honeywell RF Control Millivolt Gas Valve

Showing Piezo Ignitor Location

Figure 1

INSTRUCTIONS FOR RF COMFORT CONTROL VALVE

The Comfort Control Valve allows remote con- trol of temperature, fan and flame appearance.

Note: The antenna should hang in free air and away from any grounded metal.

Operation (refer to Figure 2, page 4 )

Step 1. If the manual switch is in the remote position, switch it to LOCAL.

Step 2. Turn the Pilotstat knob counter- clockwise from OFF to the PILOT position, push the knob down and hold it in position. The pilot valve will open and allow gas to flow to the pilot burner.

Step 3. Actuate the plunger on the piezo (several times if necessary) until the pilot burner is lit. When the pilot burner is lit, the LED on the control will come on after approxi- mately 40 seconds. The receiver/valve is fully powered.

Step 4. Release the knob. The shaft will move forward. The pilot burner should now stay burning. If the pilot burner goes out, repeat Steps 2 and 3.

Step 5. Turn the knob counterclockwise to the ON position. If the manual switch is in the LOCAL position, the main burner will turn on immediately.

LSS-40CP specifications

The Magnavox LSS-40CP is a noteworthy addition to the realm of home entertainment, combining innovative technology with user-friendly features. Launched as part of Magnavox's commitment to delivering quality audio and visual experiences, this model stands out for its versatility and functionality.

One of the key features of the LSS-40CP is its impressive display technology. Equipped with a high-definition LCD screen, it offers vibrant colors and sharp image clarity that enhance the overall viewing experience. The 40-inch display strikes a balance between size and usability, making it suitable for various room settings, from cozy living rooms to larger entertainment spaces.

Audio quality is another highlight of the Magnavox LSS-40CP. It integrates advanced sound technology that ensures a rich and immersive audio experience. The built-in speakers produce clear and powerful sound, while options for external audio connections allow users to further enhance their sound system for movie nights or gaming sessions.

Connectivity is a crucial feature of modern entertainment devices, and the LSS-40CP excels in this area. It includes multiple HDMI and USB ports, enabling seamless connections to various devices such as gaming consoles, streaming devices, and external media players. This versatility ensures that users can easily switch between different input sources, catering to an array of entertainment preferences.

The LSS-40CP also features smart technology integrations, allowing for access to streaming services and apps directly on the device. Users can easily enjoy their favorite shows and movies without the need for additional hardware. The user interface is designed to be intuitive, providing straightforward navigation for accessing content quickly.

In terms of design, the Magnavox LSS-40CP showcases a sleek and modern aesthetic that complements contemporary home decor. Its slim bezel design maximizes screen real estate while maintaining an elegant appearance.

Furthermore, energy efficiency is an important attribute of the LSS-40CP. With its advanced technology, it minimizes power consumption while delivering top-notch performance, aligning with eco-friendly initiatives and saving users on electricity bills.

In summary, the Magnavox LSS-40CP integrates cutting-edge technology with practical features, making it an attractive option for those seeking a quality home entertainment experience. Its combination of visual and audio performance, connectivity options, and smart capabilities positions it as a noteworthy contender in the market, appealing to both casual viewers and dedicated enthusiasts.