Regency GFI55 Exhaust Passages Post Season CLEAN-UP, Cleaning Plated Surfaces, Firebox Panel

Page 12

MAINTENANCE

EXHAUST PASSAGES

POST SEASON CLEAN-UP

(season)

Removal of the firebox backing for bi-annual cleaning (refer to Figure 12):

a)Open the door by lifting the handle, remove the burn pot and burn pot liner.

b)Before trying to remove screws, lubricate all screws with penetrating oil. ie. WD-40.

c)Loosen (do not remove) the four (4) screws that hold the brick liner retainers in place. Remove side brick liners by sliding them from under the screwheads.

d)Pull the center panel out. Ensure not to damage the 1" insulation attached to the back of the center panel.

e)Vacuum and clean thoroughly.

Installation of firebox backing:

a)Return center panel to its original position.

b)Place the two (2) side panels back into the firebox, secure the two

(2) retainers and lock down by tightening the two (2) screws on each side.

c)Replace the burn pot and burn pot liner.

d)Close the glass door and secure.

MAINTENANCE

Once you are finished using the pellet appliance for the season, unplug the stove for added electrical protection. It is very important that the stove be cleaned and serviced as stated above. Also remove any remaining fuel from the hopper and auger.

CLEANING PLATED SURFACES

Painted surfaces should be wiped with a damp cloth periodically.

It is important to note that fingerprints and other marks can leave a per- manent stain on plated finishes. To avoid this, give the surface a quick wipe with denatured alcohol on a soft cloth BEFORE lighting the fireplace. Never clean surfaces when they are hot. Do not use other cleaners or abrasives as they may leave a residue or scratches, which can become permanently etched into the surface.

FIREBOX PANEL

The paint on the steel firebox panels may peel. This is due to extreme conditions applied to the paint and is not covered under warranty.

REPLACING DOOR GLASS

It is recommended that your Greenfire dealer replace the glass if broken.

The door glass is made of high temperature PYRO CERAMIC 5 mm thick. The center panel is 15.4” x 9.0” (39.0 cm x 22.9 cm) and side panels are

2.6x 9.0 inches (6.7 cm x 22.9 cm). They must be replaced with (Part # GF55-028 & GF55-029). Substitute materials will not be permitted.

Figure 12: Firebox Components Removal.

12

Greenfire Pellet Stove and Insert Owner's Manual

Image 12
Contents GF55 & GFI55 FPI Fireplace Product To the NEW OwnerTable of Contents Safety Label Étiquettecette PasretirezInstallation Safety Warnings & RecommendationsUSE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW FuelImportant Safety Information Pellet QualityI. Pellet Standards Automatic Safety Features Operating InstructionsControl Board Functions Manual Mode High / LOW ModeAuto / OFF Mode Operating Your Pellet StoveHopper Grate Installation Slider / Damper Must be SET AT Time of InstallationSlider / Damper SET-UP Special NotesMaintenance Routine Cleaning & MaintenanceASH PAN Heat Exchanger TubesFresh AIR Intake Exhaust VentExhaust Passages Post Season CLEAN-UP Cleaning Plated SurfacesFirebox Panel Replacing Door GlassWarranty Limited Lifetime WarrantyExclusions and Limitations Warranty Installer Please complete the following information

GFI55 specifications

The Regency GFI55 is a remarkable gas fireplace insert that combines elegance with advanced technology, offering warmth and style to any home setting. It is engineered for efficient heating, making it an excellent choice for those seeking to enhance their living spaces with both functionality and aesthetic appeal.

One of the standout features of the GFI55 is its impressive heating capacity. With an output of up to 40,000 BTUs, it is capable of heating larger areas effectively, providing cozy warmth even in expansive rooms. This makes it ideal for open-concept designs where the heat must be distributed evenly.

The design of the GFI55 is both classic and contemporary, featuring a large viewing area that showcases the mesmerizing flames. The flame presentation is enhanced by ceramic logs, which not only look realistic but also contribute to the fireplace's overall efficiency by retaining heat.

Technologically, the Regency GFI55 boasts a range of innovative features. It includes a high-efficiency heat exchanger which maximizes heat output while minimizing energy consumption, ensuring that users enjoy warmth without excessive energy bills.

Safety is also a priority in the design of the GFI55. It is equipped with an automatic shut-off feature that activates in case of overheating, providing peace of mind for families. Additionally, the unit meets stringent safety standards, ensuring that it is a secure option for residential use.

Installation is made easy with the GFI55, which can fit into most standard fireplace openings, allowing for a straightforward retrofit into existing masonry fireplaces. This adaptability makes it an appealing choice for homeowners looking to upgrade their current heating solutions without the need for extensive renovations.

Moreover, the GFI55 offers customizable options to suit individual tastes. Homeowners can choose from different finishes and decorative trims, ensuring that the fireplace complements their home's interior design.

In summary, the Regency GFI55 gas fireplace insert is an exceptional product that marries advanced technology with elegant design. Its efficient heating capabilities, safety features, and customization options make it an excellent investment for anyone looking to enhance their home's ambiance and comfort.