Weil-McLain GV Series 4, GV Series 3 manual Hazard definitions, To the installer

Page 1

Water Boiler — Series 3 & 4

Venting Supplement

Z-Vent II

Special gas vent system vent and combustion air supplement

Z-Flex® , Inc. Z-Vent II AL29-4C®Stainless Steel Special Gas Vent System may be used in new installations of GV-3 through GV-6 boilers.

Hazard definitions

The following defined terms are used throughout these Instructions to bring attention to the presence of hazards of various risk levels or to important information concerning the life of the product.

Indicates presence of hazards that will cause severe personal injury, death or substantial property damage.

Indicates presence of hazards that can cause severe personal injury, death or substantial property damage.

Indicates presence of hazards that will or can cause minor personal injury or property damage.

Indicates special instructions on installation, operation or maintenance that are important but not related to personal injury or property damage.

To the installer:

This Venting Supplement must only be used by a qualified installer/service technician. Read these Instructions completely before beginning the installation. Failure to follow all instructions can cause severe personal injury, death or substantial property damage.

To install a new vent system follow instructions in:

This Venting Supplement.

GV Boilers Vent/Air Intake Termination Assembly Instructions, if using Weil-McLain Vent/Air Intake Termination Kit. — OR —

GV Water Boiler Series 3 & 4 Direct Vent Through-Roof or Through- Unused-Chimney Venting Supplement, if using Weil-McLain Through-Roof or Through-Unused-Chimney Termination Kit.

Z-Vent II manufacturer’s instructions supplied with vent material. For installations above 5,500 feet use only direct vent (ducted combustion air) when sidewall venting. All of the vertical (through-roof or through- unused-chimney) methods in this Venting Supplement are acceptable and can result in severe personal injury, death or substantial property damage if ignored.

Part number 550-110-266/0601

Image 1
Contents Hazard definitions To the installerSpecial note Combustion air supplyProducts to avoid Areas likely to have contaminantsVenting method definitions Vent terminationProperly locate vent termination Pre-installation planning InstallationDescription Flex , Inc Part Number Note Slope Select vent methodConnect vent starter tee to boiler Installation assemblyConstruct vent and optional combustion air run Connect vent run to terminationVent Installing condensate tubing Finish the vent installationIf vent pipe or combustion air pipe must be reassembled