Quasar HQ-2244UH operating instructions Cabinet Installation, Window stop moldings

Cabinet Installation

1.	Open the window. Mark a line on the center
	of the window stool between the side
	window stop moldings.
	Loosely attach the sill bracket to the support
	bracket using the carriage bolt and the lock
	nut. (See Fig. 5)
2.	Attach the sill bracket to the window sill
	using the screws (Type B).
	Carefully place the cabinet on the window

Sill
Bracket	Support
	Bracket

Carriage

Bolt Lock nut (M-Screw)

Fig. 5

stool and align the center mark on the

bottom front with the center line marked

window stool.(See Fig. 6)

3. Using the M-screw and the lock nut, attach

the support bracket to the cabinet track hole.

Use the first track hole after the sill bracket

on the outer edge of the window sill. Tighten

the carriage bolt and the lock nut. Be sure

Cabinet

Track hole

Support

Bracket

Carriage bolt and lock nut

Machine screw(Type D) and lock nut

Outer edge of window sill

Screw(Type B)

Sill bracket Fig. 6

Features and Installation

the cabinet slants outward. (See Fig. 6)

CAUTION: DO NOT DRILL A HOLE IN THE BOTTOM PAN.

The unit is designed to operate with approximately 12.7mm(1/2") of water in bottom pan.

4.Pull the bottom window sash down behind the Top retainer bar until they meet. (See Fig. 7)

NOTE: 1. Do not pull the window sash down so tightly that the movement of Frame curtain is restricted. Attach the cabinet to the window stool by driving the screws (Type B) through the cabinet into window stool. (See Fig. 8)

2.The cabinet should be installed with a very slight tilt downward toward the outside.

Window sash Top retainer bar

Foam-PE

Cabinet

Frame curtain

Foam-PE

Fig. 7

Sash track

	Front Angle
Screw(Type B)	Fig. 8

12