Quasar HQ-2244UH operating instructions About the Controls on the Air Conditioner

About the Controls on the Air Conditioner

Controls

2 6

	1		OPERATION
			TEMP
8			3
		TIMER	AIR
	6		SWING
			7
		MODE	FAN SPEED
1	2		4
	5	ECONOMY

4 3 7

Precaution: The Remote Controller will not function properly if strong light strikes the sensor window of the air conditioner or if there are obstacles between the Remote Control

About the Controls on the Air

unit and the air conditioner.

OPERATION BUTTON

•To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.

•This button takes priority over any other buttons.

•When you first turn it on, the air conditioner is on the High cool mode and the temp. at 72°F(22°C)

OPERATION MODE SELECTION BUTTON Every time you push this button. It will toggle between COOL, ECONOMY, FAN and DRY.

ROOM TEMPERATURE SETTING BUTTON This button can automatically control the temperature of the room. The temperature can be set within a range of 60°F to 86°F by 1°F. (16°C to 30°C by 1°C)

Select the lower number for lower temperature of the room.

FAN SPEED SELECTION BUTTONS Every time you push this button, it is set as follows.

{High(F3) → Low(F1) → Med(F2) → High(F3)...}.

ECONOMY

•If you push the button, the fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.

6ON/OFF TIMER BUTTON

You can set the time when the unit will turn on or turn off automatically by pressing the timer button. If the unit is operating, this button controls the time it will be turned off. If the unit is in off state, this button controls the time it will start. Every time you push this button, the remaining time will be set as follows.

-STOPPING OPERATION

•Every time you push this button, when the air conditioner is operating, timer is set as follows. (1Hour → 2Hours → 3Hours → 4Hours → 5Hours → 6Hours → 7Hours → 8Hours → 9Hours → 10Hours → 11Hours → 12Hours → 0Hour → 1Hour → 2Hours → ...)

•The Setting Temperature will be raised by 2°F(1°C) 30min. later and by 2°F(1°C) after another 30 min.

- STARTING OPERATION

•Every time you push this button, when the air conditioner is not operating, timer is set as follows. (1Hour → 2Hours → 3Hours → 4Hours → 5Hours → 6Hours → 7Hours → 8Hours → 9Hours → 10Hours → 11Hours → 12Hours → 0Hour → 1Hour → 2Hours → ...)

7AIR SWING BUTTON

This button can automatically control the air flow direction.

8REMOTE CONTROL SIGNAL RECEIVER

9DRY

•When this unit is in dry mode, the fan rotates in low speed. The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on and the unit checks the room air temperature to set itself.

Conditioner

5