Note:
After installation, please refer to operation, maintenance and troubleshooting sections in this manual. If your fan is packaged with a light kit or
if you wish to install a separately purchased light kit, please refer to the insert sheet titled: Light Kit Installation
7
8 |
|
| Standard wiring option | ||||||
|
| ||||||||
|
|
| Black |
| House |
| Fan | Black |
|
|
|
|
|
| |||||
|
|
|
|
|
|
| |||
* Attach blue wire |
|
|
|
|
|
| Blue * |
| |
only if attaching |
|
|
|
|
|
|
|
| |
White |
|
|
|
| White |
| |||
light kit with fan |
|
|
|
|
| ||||
|
| Green |
|
|
|
|
|
| |
|
|
|
|
| Green(Downrod) |
| |||
|
|
|
|
|
|
|
Secure with
Green(Bracket)
Carefully lift fan assembly onto mounting bracket. Rotate fan so that the notch on the ball engages the ridge in the mount- ing bracket. This will allow
9 | Wiring option with wall speed control |
For pullchain controls, follow diagram above. Make sure that all exposed wiring is secured inside wire nuts. Note: Wires from house may vary in color and may not include ground wire. After wiring is conplete, gently push wires into junction box with wire nuts pointing upward. Refer to point 3 of safety tips.
10
Fan Switch
Light Switch
Wall
Control
For control of fan and optional light from wall location, follow diagram above. NOTE: A pro- fessional electrician is recommended for this type of installation. Ceiling fan is suit- able for use in wet locations when installed in a GFCI protected branch circuit (outdoor fans only).
11
Fiber washers
Attach blade brackets to blades using the blade bracket screws and washers provided.
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Secure with two 5/32 x 1/2” screws provided.
12
Shipping stabilizer tab
Remove plastic shipping stabilizer tabs from motor, if present. The screws, washers and motor pads are