Before connecting the hoist to its air supply line; perform the proper draining and purging procedures to prevent contaminants or moisture from entering the hoist.
3.7Mounting Location
Prior to mounting the hoist ensure that the suspension and it supporting structure are adequate to support the hoist and its loads. If necessary consult a professional that is qualified to evaluate the adequacy of the suspension location and its supporting structure.
3.7.2
NOTICE
See Section 7.6 for outdoor installation considerations.
3.8Connecting Hoist to Air Supply
3.8.1
WARNING HAZARDOUS AIR PRESSURE IS PRESENT IN THE HOIST, IN THE SUPPLY OF COMPRESSED AIR TO THE HOIST, AND IN THE CONNECTIONS BETWEEN COMPONENTS.
Figure 3-4 Typical Air Supply Connection
3.8.2Shut off the air supply and stop the airflow completely. Lock out and tag out in accordance with ANSI Z244.1 “Personnel Protection -Lockout/Tagout of Energy Sources”.
Before connecting the air supply hose to the hoist, always purge the air hose to clear any debris and water.
3.8.4Apply approximately 10-15 drops of turbine oil (see approved lubricant under Section 6.0 Lubricants) into the hose before attaching to the hoist.
3.8.5Make connections to air supply; reference Figure 3-4. Use a reducing adapter at the hoist valve section for hose sizes larger than 1 inch.
3.8.6 |
| NOTICE | Where conditions dictate, the installation sequence can be reversed by mounting |
|
| ||
| the hoist first (Section 3.9) followed by connecting the air supply (Section 3.8). | ||
3.9Mounting the Hoist
3.9.1Manual Trolley - Follow instructions in Owner’s Manual provided with the trolley.
3.9.2Motorized Trolley - Follow instructions in Owner’s Manual provided with the trolley.
3.9.3Hook Mounted to a Fixed Location - Attach the hoist’s top hook to the fixed suspension point.
Ensure that the fixed suspension point rests on the center of the hook’s saddle and that the hook’s latch is engaged .
15
