Speed Selection and Controls

These recirculation models are equipped with a 3 speed control, low medium and high, (Note - 1000RHC/RHCAC must be set to high speed when air conditioning is required), as well as a lighted on/off switch and a low voltage terminal strip. The low voltage terminal strip is used to connect the supplied dehumidistat.

Air Conditioning (DX) Coil

Model 1000RHCAC Only

The Direct Expansion (DX) Coil located inside the cabi- net is designed to dehumidify the incoming fresh air from the outside and is not intended as an air condition- ing unit for the space. The coil must be connected to an outdoor condensing unit, (this unit or it’s controls are not provided by NUTECH). Special care and atten- tion should be given to ensure the Model 1000RHCAC is set to high speed during air condi- tioning mode, to avoid the coil from freezing up.

DEHUMIDISTAT

END OF UNIT

not used

ON/OFF SWITCH

3 SPEED CONTROL

		idistat
Dehum			tive to
Setting		Rela		ions
Outside		Condit
	WINTER		:
Set	dehumidistat
		30%	to 40%.
een				dry,
betw		e is too
If hom				setting.
adjust to higher				id,
If home is too hum .
adjust to		lower setting
	SUMMER
		idistat
Set dehum
	to OFF.

HIGH

COMMON

* NOTE: The external low voltage contacts on a pool

	PART NO. 99-130W	unit control the Ventilation/Recirculation
		Damper only, not low/high speed control.
	•Provides ventilation or recirculation mode

Hydronic Reheat Coil

Model 1000RHC and 1000RHCAC

DISCLAIMER

The coil is designed to temper the air delivered through the HRV, to room temperature and is not a heating appliance for the space.

Special care and attention should be given to selecting a thermostat which will be connected to the pump feeding the coil. The thermostats function will be to signal the pump to send water through the system if temperatures drop below 40˚F (5˚C) to prevent the coil from freezing and also to shut the pump off if the air temperature leaving the coil exceeds 77˚F (25˚C) to prevent over heating motors.

Thermostats and pumps not available from NUTECH.

The Model 1000RHC and RHCAC is intended to be installed by certified HVAC trades people. Damage resulting in partial or complete failure of the Reheat/Air Conditioning portion is the respon- sibility of the installing contractor. Precautions should be put into place to avoid these coils from freezing or causing the motors to overheat or any other unforeseen problem not mentioned here.

The DX Coil is supplied with an orificing device suitable for 1.5 tons of air conditioning @ 95˚F 80% RH inlet air.

1200DDPOOL, 700DDPOOL, 1000RHCAC, 1000RHC specifications

Lifebreath is a brand renowned for its commitment to energy-efficient indoor air quality solutions. Among their offerings, the Lifebreath 700DDPOOL, 1200DDPOOL, 1000RHCAC, and 1000RHC stand out as exemplary products designed for various residential and commercial settings. These units leverage cutting-edge technologies to provide superior ventilation, heat recovery, and air quality management.

The Lifebreath 700DDPOOL is specifically designed for indoor pools and similar environments. This model boasts dual-flow ventilation, which simultaneously circulates fresh air into the space while expelling stale air. The 700DDPOOL features a built-in dehumidistat, ensuring optimal humidity levels are maintained, which is vital for preventing mold and preserving air quality. Its energy recovery capabilities make it an eco-friendly choice, reclaiming heat from exhaust air to pre-condition incoming air, thus significantly reducing heating costs.

The Lifebreath 1200DDPOOL offers similar benefits but on a larger scale. With a higher airflow capacity, the 1200DDPOOL is ideal for larger pool areas or heavily used commercial spaces. It also incorporates advanced filtration technologies that trap allergens, dust, and pollutants, resulting in cleaner air. Both the 700DDPOOL and 1200DDPOOL are engineered for easy installation and maintenance, with features like removable filters and accessible components.

The Lifebreath 1000RHCAC and 1000RHC models shift focus towards whole-home ventilation and air conditioning solutions. The 1000RHCAC combines heat recovery with air conditioning capabilities, allowing for year-round climate control. The unit’s heat exchanger efficiently recovers heat from the outgoing air and transfers it to the incoming air, ensuring that energy is conserved even during cooling seasons.

In contrast, the Lifebreath 1000RHC emphasizes effective heat recovery without an integrated air conditioning system, making it an excellent choice for areas where cooling is not a priority. Both models boast a quiet operation, ensuring no disruption to daily living, along with energy-efficient certifications that appeal to eco-conscious consumers.

Overall, Lifebreath’s 700DDPOOL, 1200DDPOOL, 1000RHCAC, and 1000RHC models provide exceptional performance, versatility, and user-friendly features. These air management systems represent the future of sustainable indoor air quality solutions, meeting diverse ventilation needs while prioritizing energy efficiency and comfort. With Lifebreath, users can breathe easier knowing they have invested in cutting-edge technology designed for health and efficiency.