To Disarm a system in alarm:
1.Enter your [ACCESS CODE].
2.In the case of a false alarm, call your Central Monitoring Station quickly to advise them of the false alarm.
In the case of a burglar alarm, leave the premises and call the Police from a safe place.
4.3ALARM MEMORY DISPLAY
Your system will record all the alarms that occurred during the last armed period. The zones in alarm will remain in the Alarm Memory until the next time that area is armed.
When an alarm has occurred, the LCD screen will display “Alarms in Memory [MEM] to View”.
1.Press the [MEM] button. Each zone that was breached while armed will appear below “Alarm in:”.
2.Press the [CLEAR] button to exit the Alarm Memory Display.
5.0 ACCESS CODES
Access Codes allow access to the system. Your system supports up to 96 User Access Codes. Codes are given a User Number between 02 and 96 (User Number 01 is the System Master Code). Your Installer will program User Access Codes to be four, six, or variables of one to six digits in length. Each digit can be any value between zero and nine. If your Installer programmed your system to accept a variable code length, you have to press the [ENTER] button after entering your User Access Code.
5.1SYSTEM MASTER CODE (Default 123456)
The System Master Code will give you access to all the features available on your system, as well as the ability to add, modify, or delete any User Access Codes. We suggest that you change this code to prevent others from accessing and changing options without authorization. Your Installer can set The System Master Code to be either 4 or 6 digits in length.
To change the System Master Code:
1.Enter the current [SYSTEM MASTER CODE] (default: 123456).
2.Press the [0] button.
3.Press the [ACC] button.
4.Enter the number [01].
5.Enter a [NEW CODE].
6.Press the [ENTER] button to save and exit.
The System Master Code has access to all Access Control Doors and all Access Control features at all times. Only the card’s serial number and the choice of arming method can be changed. If the other options are manually changed, the System Master Code will immediately revert to its original programming.
5.2DELETING USER ACCESS CODES
To delete User Access Codes, follow steps 1 to 5 in Figure 5.1 on page 9, but press the [CLEAR] button in step 5. Once the information is erased, press the [ENTER] button to save and exit.
5.3PROGRAMMING USER ACCESS CODES
The System Master and Users with the Master feature can program User Access Codes with User Options and Area Assignments. Figure 5.1 on page 9 describes the steps you would follow to program User Access Codes.
If the keypad emits a Rejection Beep at any point during the programming procedure, you may have chosen an existing User Code or you do not have access to certain User Options (section 5.4) and Area Assignments (step 7 in Figure 5.1 on page 9). User’s with the Master feature can only assign User Options and Area Assignments that they are assigned to. For example, if a User with the Master feature is assigned User Option 1 and Area 2, they can only assign Options 1 and Area 2 to a User Access Code.
8 System Manager’s Manual