ELECTROGLIDE 5
ASSEMBLING VACUUM SYSTEM
Before assembling your Electroglide Electric Powerhead,
be sure you have all parts shown in PARTS AND FEATURES.
WARNING
Do not plug into electrical supply until assembly is complete. Failure to do so could result in electrical shock or injury.
Hose
Handle
Handle Button
Upper
Wand
Button
Lock
Wand
Swivel
Suction Control
Plug
Holder
Power
Cord
Cord
Holder
Lower
Wand
Wand
Button
1.Connect the upper and lower wand sections. (The wand swivel is located on the lower wand.)
2.Slide the upper and lower wands together until the wand button snaps into place. Turn wand button to the slotted area of the wand swivel. (The swivel allows you to turn the handle to the left side to reach farther under low furniture.)
3.Insert the wand assembly into the wand socket located on the neck of the electric powerhead. The lower wand button lock will prevent the wand assembly from detaching from the Electroglide while in use.
4.Plug the power cord from the wand assembly into the receptacle at the top of the upper wand. DO NOT FORCE.
5.Secure the electric cord into the cord holder on the wand swivel.
6.Insert the hose handle into the wand assembly. Insert the hose wall adapter into the vacuum inlet valve. Plug the 120V power cord into the nearest electrical outlet.
Wand Easy Release Pedal
To remove wands, disconnect the power cord and step on the wand release pedal, then pull up on the wands.