H-P Products Electroglide owner manual Belt Removal, To replace belt

Page 10

10ELECTROGLIDE

MAINTENANCE AND CARE

Belt Removal (continued)

6. Remove worn belt.

7. Slide brush supports off to check and clean brush support areas.

To replace belt:

1.Slide washers and brush supports onto brush assembly.

3.Snap brush supports into place on base. Be sure brush supports are not upside-down.

2.Install new belt over motor drive, then over brush sprocket.

	Motor
	Drive
	Brush
Brush	Brush Sprocket
Support

4.Line up front of cover and base. Rest cover on front edge of base as shown.

Cover

Base

Image 10

Contents Electroglide Table of Contents Important Safety Instructions Read all instructions before using this vacuum systemParts and Features ElectroglideAssembling Vacuum System Electroglide Attachments Wand Assembly AttachmentsGeneral Operation Hose Handle Attachments Overload Protector Performance Features Edge Cleaner Suction ControlBrush Cleaning Maintenance and CareLight Bulb Replacemnent Belt Removal and Replacement To remove beltBelt Removal To replace beltBelt Replacement Brush ReplacementElectroglide Replacement Parts Illus Part Description 7941Limited Warranty Service Information PRODUCTS, INCProducts, Inc