Fig 3
Tank
Release
Fig 4a
Fig 5a
Fig 7 a
b
Fig 8
pg 10
Operating Instructions: (cont)
| Using Your Steam Vacuum Cleaner: | |
| STEAM Only Function: | |
|
|
|
| 4) Before using the Steam Function you need to fill | |
| the water tank. Press the Release button (Fig 3) | |
| to remove the tank. Pull up and out. (Fig 4a & 4b) | |
| 5) Open the water tank cap (Fig 5a) and fill the water | |
| tank directly with water up to the maximum | |
Fig 4b | indicator line visible on the clear plastic tank | |
| window. (Fig 5b) Then make sure to secure the cap | |
| back on the water tank. Twist the water tank cap | |
| slightly left and right to push closed. If the water | |
| tank cap cannot be closed securely, lightly wet the | |
| rubber portion of the cap and close. The use of | |
| distilled water is recommended, especially in areas | |
| of hard water. Replace the tank by snapping it back | |
Fig 5b | into place on the body of the |
6)In order to use the STEAM function you need
MAX | to put the Pad Tray on the bottom of your unit | |
to hold the | ||
Fill | ||
|
7)There are 4 raised buttons on the underside of the base of the
8)Set the Pad Tray on the floor with the indents facing up. Align the buttons and press together
until you hear the tray snap into place. (Fig 8) The Pad Tray has the required ‘nubs’ to hold the
9) Set the
10)Plug your unit into a grounded receptacle. The POWER light will light up RED to indicate that the power is ON. (Fig 9)
11)Press the STEAM button on the center control
to start the steam function. The STEAM light will light up ORANGE and the unit will begin to heat. (Fig 10) Leave the unit on the Resting Pad for the time it takes (under 1 minute)for the unit
to be ready to steam. The unit is ready when you
Fig 9 |
| Fig 10 | |||
| ON | ON |
|
|
|
|
|
|
| ||
|
|
|
|
| |
|
| Push |
|
| |
|
|
|
877 - HAAN DIRECT / 877 - 422 - 6347 | www. H A A N USA . com |