Using Your Steam Vacuum
Using the Steam & Vacuum Function Together:
Fig 15
ON
Fig 16
All
ON
Push
Both
Fig 17
!CAUTION
Never use with detergents and/or soapy water in the water tank. Using the Steam Vacuum other than as recommended in this manual could damage the unit and void the warranty.
Your
14)In order to use the Vacuum and Steam function simultaneously you need to be sure there is water in the tank. Follow the filling instructions as outlined in steps 4 & 5 on page 10.
15)Set the
16)With the unit sitting on the Resting Mat, plug your unit into a grounded receptacle. The POWER light will light up RED to indicate that the power is ON. (Fig15)
17)Press the STEAM and VACUUM button on the center control to start the dual function. Pressing BOTH will light up the STEAM (Orange) and the VACUUM (Green) indicator lights. (Fig 16.)
18)Leave the unit on the Resting Pad for the time (under 1 minute)it takes for the unit to be ready to steam. The unit is ready when you see sweating on the surface of the Resting Mat and steam being emitted from the bottom of the
13)You are now ready to vacuum any surface in your home and sanitize them at the same time. Move the unit back and forth over the area to be vacuumed and sanitized. (Fig 17)
Adding Water During Use:
14)Turn power OFF.
15)If the Steam function has been used, allow the unit to cool down before proceeding, for approximately 5 minutes.
!CAUTION
The
16)To add water, follow steps
17)After filling the water tank, set the
18)Plug the unit in and proceed to use the unit as described in the instructions for the function you choose.
pg 12 | 877 - HAAN DIRECT / 877 - 422 - 6347 | www. H A A N USA . com |