Fantom Vacuum FM604 owner manual Precautionary Measures, Cleaning & Changing the Hepa Filter

PRECAUTIONARY MEASURES

OPERATING INSTRUCTIONS cont.

IMPORTANT: If the suction opening in the unit or the hose is BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.

Cleaning & Changing the HEPA Filter (cont.)

PLEASE NOTE: The white pleated

Changing & Cleaning the Pre- Motor Filter

The pre-motor filter is a washable filter but should be replaced every three (3)

1.Do not operate the vacuum cleaner too close to heaters, radiators or cigarette butts.

2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.

3.Before you start vacuuming, make sure to remove large or sharp objects that might damage the dust cup debris screen.

4.When pulling out the power plug from the wall outlet, pull the plug not the power cord.

5.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.

6.Do not use without HEPA filter in place.

filter material in the HEPA Filter will discolor over time -This is NORMAL and will NOT affect the performance of the filter. If the HEPA Filter

is properly
"TapCleaned”	Fig. A
after each use	Wash
and suction	once a
does not return	month or
to 100%, then	when
we suggest that	suction
the HEPA filter	appears
	reduced
be “TapCleaned”
vigorously until	Warning: Allow 24
no more dust	hours for drying before
can be removed,	replacing in unit.
then rinsed

under the faucet and allowed to air dry for 24 hours before refitting into the

vacuum. (Fig. A) This should be done once a month or when suction appears to be reduced .

CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

Warning: Always empty the dust cup container and clean the HEPA filter and Debris Screen before each use and during prolonged usage.

Never over fill the dust cup container - remove dirt and clean the HEPA filter and debris screen when dirt in dust cup is at or below the "MAX" level during prolonged usage or risk motor damage.

If you wash the Hepa filter, make sure that it is completely dry before inserting back in the vacuum.

months.

•Remove the dust cup container and the HEPA filter to remove the pre- motor filter.

•Rinse the pre-motor filter in lukewarm water and air dry the filter completely for 24 hours. Do not use a washing machine to rinse the filter. Do not use a hair dryer to dry it. Air dry only. Never operate the vacuum without the pre-motor filter in place.

•When the filter is dry, replace into the unit and replace the HEPA filter and dust cup container.

•A severely soiled or clogged filter should be thoroughly washed with fresh tepid water. A mild detergent can be used if required.

Pre-Motor

Filter

Changing & Cleaning the Post Motor Filter

The post motor filter is a washable filter but should be replaced every three (3) months.

• Remove the filter cover from the front

of the unit and remove the filter.

• Rinse the post

motor filter in

lukewarm water

and air dry the

filter completely

for 24 hours. Do

not use a washing

machine to rinse

3

Please Note: The HEPA Filter is
washable. It should, however, be
replaced every six (6) months to ensure
peak performance of your vacuum.
Both the Pre-Motor and Post Motor
Filters are washable. They should
however be replaced every three (3)
months to ensure peak performance of
your vacuum.
Important: Make sure that ALL filters
are completely dry before re-installing
back in the vacuum.	8

the filter. Do not

use a hair dryer to

dry it. Air dry only.

Never operate the

vacuum without the

post motor filter in place.

• When the filter is dry, replace into the

filter cover and replace the filter cover

to the unit.

• A severely soiled or clogged filter

should be thoroughly washed with

fresh tepid water. A mild detergent

can be used if required.