Fantom Vacuum FM744H instruction manual Replacing the Flat Belt

Page 17

REPLACEMENT INSTRUCTIONS

Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below.

REPLACING THE FLAT BELT

Remove the bottom plate.

1 (refer to page 16)

Lift out the agitator assembly, and then remove the flat belt from the motor shaft and

2 the agitator pulley.

Motor Shaft

Flat Belt

3 Place a new flat belt onto the motor shaft and pulley.

Motor Shaft

Flat Belt

Flat Belt

Pulley

Place the agitator assembly into the grooves in the nozzle head, making sure that the new

4 flat belt slides securely into the guide.

Bearing Holder

Groove

Nozzle Head

Reattach the bottom plate

5 (refer to page 16)

Caution:

Install the flat belt so that it has no twists in it, and so that all components turn smoothly.

15

Image 17

Contents FM744H Page Read ALL Instructions Before Using this Vacuum Cleaner Important Safety InstructionsGrounding Instructions Front Rear Names of Each PartAttaching the handle Preparations Before USEPrep ARA Tions Before USE Inserting the Power Cord PlugDI NG T HE P OW ER C or D L E a S in G T HE P OW E R C or DAdjusting the Handle Using the Vacuum CleanerON/OFF Switch RUG/FLOOR Toolsselector Height Adjustment LeverEdge Cleaning Upholstery tool & Dusting brush Using the AttachmentsHose Attachment AIR Driven Turbo Brush Using the Unit With Air Driven Turbo BrushEmptying the Dust Compartment Power cord from the wall outlet before cleaningCleaning Utensil Cleaning the FiltersClearing Blockages and Cleaning the Agitator Assembly Replacing the Headlight Lamp Replacement InstructionsReplacing the Flat Belt Reattaching the Bottom Plate Removing the Bottom PlateReplacing the Filter Cleaning the SUB-FILTERProblem Cause Remedy TroubleshootingFive 5 Year Limited Warranty