Replacing the Filter

Seal

Filter Cover

REPLACEMENT INSTRUCTIONS

Under normal usage, the HEPA Filter will require replacement once every three (3) months, however, vacuuming large amounts of extremely fine dust, powder or similar material over a long period of time may decrease airflow performance through the filter. If this occurs, it may become necessary to replace the HEPA Filter more often. Only use genuine FANTOM replacement filters.

	Press in the locking tabs at points 1	1
	1 and pull the filter cover away from the	1
	1 and pull the filter cover away from the	1

vacuum cleaner.

2 Remove the HEPAfilter.

Caution:

HEPA Filter

Do not attempt to wash the HEPA filter. Always replace the old filter with a new one.

Insert a new HEPAfilter with the seal

3 to the inside of the vacuum cleaner. Reattach the filter cover.

Caution:

Be sure that seal on the HEPAfilter is inserted towards the inside of the vacuum cleaner.

The filter cover should be correctly oriented

when it is reattached. Do not reattach it upside down.

CLEANING THE SUB-FILTER

Clean the sub-filter when it becomes dirty.

Remove the dust compartment

1 (refer to page 8).

Remove the air inlet cover.

2	Air Inlet
Remove the sub-filter from the vacuum cleaner.		Sub-Filter
	Cover
1

Gently clean the sub-filter with water.

Make sure that it is completely dry and 4 then re-install it into the vacuum cleaner.

Replace the air inlet cover and the dust compartment.

Caution: Do not wash the sub-filter in a washing machine, and do not use any other equipment such as a hair dryer to dry it. Always allow 24 hours for drying. Do not operate

the vacuum without the sub-filter. Be sure the sub-filter is dry and properly installed. Failure to do so could result in electrical shock, personal injury, or motor failure.

Note: We recommend replacing the sub-filter every three (3) to six (6) months, depending on usage.