Computer Expressions 40CG, CS018-030, 38CG manual Location of Clock Set Button On Remote Control

INFRARED SIGNAL TRANSMITTER WINDOW

TEMPERATURE SENSOR

CLOCK

TIMER START/STOP ONE-TIME/DAILY INDICATORS

MODE BUTTON

OPERATION MODE INDICATORS - COOLING, FAN, HEATING, DEHUMIDIFICATION, AUTO

FAN INDICATORS -

LOW, MEDIUM, HIGH, AUTO

TIMER SET BUTTONS*

TRANSMISSION INDICATOR

LOW BATTERY INDICATOR

S TA R T
S T O P		UP/DOWN BUTTON
1 2 3	S L E E P
DA I LY
MODE	FAN	SWEEP

DESIRED TEMPERATURE

III I III
II	I
I	I
I	I
II II
			SENSOR ACTIVE INDICATOR
A		A
			SWEEP INDICATOR
TIMER			ON/OFF BUTTON
SET	DELAY
CLEAR			CLOCK BUTTON*
		ROOM
	SENSE		CLOCK

ROOM TEMPERATURE BUTTON*

DELAY BUTTON*

SLIDE DOWN PANEL

LOCAL SENSING BUTTON

beep

UNIT

S

T

S

A

PT

1R

O

T

D 2 A IL 3 Y

MS

OL

DE

E	EP
	NFA

A

S

PW

E

E

A

REMOTE

A

A

*Buttons located behind slide down panel.

Fig. 4 — Remote Control

PROGRAMMING TIME PERIODS — The duct free sys- tem can be programmed to operate at desired levels. Be sure to set the clock before programming the system.

•Increments of time are in 10 minute intervals.

•The Timer Start/Stop indicator light on the unit is on when a time period is set. See Fig. 4.

•The remote control displays the Start/Stop time of the time period that is closest to the current time. If the unit is ON, “STOP” and the time period is displayed. If the unit is OFF, “START” and the time period is displayed.

IMPORTANT: Be sure to point the remote control toward the unit while pressing the TIMER or SET buttons.

Setting Start/Stop Time — Timer feature is used to set unit operation Start/Stop times. Three different time periods up to 10 hours apart and within 24 hours can be programmed using this feature.

1.Slide down front cover of controller below ON/OFF but- ton. See Fig. 4.

S TA R T
S T O P
1	2	3	S L E E P
DA I LY
	MODE			FAN	SWEEP
	I I	III
	III	II
	III I
	A			A
TIMER
SET			DELAY
CLEAR
			SENSE		ROOM	CLOCK

Fig. 5 — Location of Clock Set Button

on Remote Control

4