Update procedure | |
1 | Press RECEIVER followed by SETUP on |
| the remote controller. |
| Main menu will be displayed on TV screen. |
| Procedures thereafter can also be performed on |
| the AV receiver/controller by using its |
| SETUP, arrow, and ENTER buttons. |
2 | Go to “ Hardware Setup” menu. |
3 | Go to “ Firmware Update” menu. |
| Note that the Firmware Update option will be |
| grayed out about 50 seconds after the AV |
| receiver/controller is turned on. Please wait. |
4 | Select “ via NET” and press ENTER. |
5 Select “ Update” and press ENTER. | |
| Updating will begin. |
| As the updating progresses, the TV screen may |
| disappear depending on the program updated. |
| In this case, you can see the update progress |
| on the front display of the AV |
| receiver/controller. The TV screen will |
| reappear when you finish the update and turn |
| on the AV receiver/controller. |
6 | Message “ Complete!” appears on the front |
| display of the AV receiver/controller, |
| indicating that the update has been |
| completed. |
7 | Using ON/STANDBY on the front panel, |
| turn off and on the AV receiver/controller. |
| Do not use ON or STANDBY on the remote |
| controller. |
| Congratulations!! Now you have the latest |
| firmware on the AV receiver/controller. |
(Go to the next page for troubleshooting.)
4