Integra DTR-5.8 instruction manual Using Zone, Controlling Zone 2 from the AV receiver

Zone 2—Continued

5Press the [Setup] button.

The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

Using Zone 2

This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2.

Controlling Zone 2 from the AV receiver

1 2

1To turn on Zone 2 and select an

input source, press the [Zone 2] button repeatedly.

Alternatively, press the [Zone 2] button followed by an input selector button within 8 seconds.

Zone 2 turns on, the Zone 2 indicator lights up, and the ZONE 2 12V TRIG- GER OUT goes high (+12 V).

To select AM or FM press the [Tuner] input selector button repeatedly.

To select the same source as that of the main room, press the [Zone 2] button repeatedly until “Z2 Sel: Source” appears.

2To turn off Zone 2, press the Zone 2 [Off] button.

Controlling Zone 2 with the Remote Controller

Zone 2

Standby/On

Iuput

Selector

Level –/+

Note:

•To control Zone 2, you must press the remote control- ler’s [Zone 2] button first.

1	Press the [Zone 2] button, then
	point the remote controller at the
	AV receiver and press the
	[Standby/On] button.
	Zone 2 turns on, and the ZONE 2 12V
	TRIGGER OUT goes high (+12 V).
2	To select an input source for
	Zone 2, press the [Zone 2] but-
	ton, followed by an Input Selector
	button.
	To select AM or FM press the [Tuner]
	Input Selector button repeatedly.

3 To turn off Zone 2, press the

[Zone 2] button, followed by the [Standby/On] button.

86